User manual X10 VT32A

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the interference by one or more of the following measures. · Reorient the antenna of the radio/TV experiencing the interference. [. . . ] To connect the Video Sender you just need to identify the last component in the chain and connect its LINE OUT jacks to the Video Sender's A/V jacks. If the last component in the chain does not have spare LINE OUT jacks, reconnect the TV to the last component in the chain using the included COAX cable to connect the VHF/UHF ports, then use the A/V connections for the Video Sender. Point the small tubular antenna up if you intend to use the IR Extender feature (See page 7). TV A/V Cable Coaxial Cable DVD Player DBS (S atellite) Receiver Cable Box IF YOU WANT TO USE YOUR VIDEO SENDER TO TRANSMIT FROM YOUR STEREO SYSTEM ONLY a) Connections for a TV with A/V OUT jacks. Just hook up the Video Sender using only the red and white jacks for the right and left channels of the audio signal. Leave the yellow (video) jack unconnected. 4 5 THE REMOTE EXTENDER FEATURE If you get a picture but the quality is poor: The Remote Extender feature allows X10 universal remotes to control some models of RCA DBS Receivers from another room. For example, you can change channels on your Satellite Receiver while viewing in another room. To use the Remote Extender Function you need to use the included Remote Extender Cable. Connect the other end of the cable to the IR Control input on the RCA DBS Receiver (DBS II or later model). To operate the controls on the RCA DBS Satellite Receiver from another room, just press the appropriate buttons on the remote (in SAT mode). The remote sends RF signals directly to the Video Sender, even through walls. The Video Sender passes these signals through the Remote Extender cable to the RCA DBS Satellite Receiver. The system usually works best with the flat side of the antennas facing each other (see diagram below). Sometimes, however, reflections and other effects in the home might affect the signal so that some adjustment of either the Sender or Receiver antenna may be necessary to get the best the signal. Point antennas at each other TROUBLESHOOTING If you do not see a picture on your TV: Check that the Sender and the Receiver are on the same letter channel (A, B, C, or D). If you are using the RCA jacks, make sure you are using the appropriate input mode for your TV, try pressing the A-B button or Video button on your TV's remote control to change the input mode (consult your TV's owner's manual, if necessary). If you are using the COAX cable, verify that the Receiver and the TV are on the same channel (3 or 4). If you connected the Receiver to a VCR and then connected the VCR to your TV, you might need to turn the VCR OFF to see the picture on your TV. Or you might need to turn the VCR on, AND set it to record the picture from the Video Sender, in order to see the picture on your TV. [. . . ] (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. CALL 1-800-675-3044, OR VISIT WWW. X10. COM, OR E-MAIL SALES@X10. COM TO OBTAIN A RETURN MERCHANDISE AUTHORIZATION (RMA) NUMBER. [. . . ]