User manual WHIRLPOOL WTW8500BC WARRANTY INFORMATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WTW8500BC. We hope that this WHIRLPOOL WTW8500BC user guide will be useful to you.


WHIRLPOOL WTW8500BC WARRANTY INFORMATION: Download the complete user guide (113 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WTW8500BC ENERGY GUIDE (373 ko)
   WHIRLPOOL WTW8500BC DIMENSION GUIDE (505 ko)
   WHIRLPOOL WTW8500BC USE & CARE GUIDE (5100 ko)
   WHIRLPOOL WTW8500BC INSTALLATION GUIDE (4701 ko)

Manual abstract: user guide WHIRLPOOL WTW8500BCWARRANTY INFORMATION

Detailed instructions for use are in the User's Guide.

[. . . ] 5" (114 mm) 39" (990 mm) Recessed area or closet installation 3" (76 mm) Minimum diameter for a standpipe drain: 2" (51 mm). Top of standpipe must be at least 39" (990 mm) high; install no higher than 96" (2. 2 (155 cm2) 1" (25 mm) 1" (25 mm) 3" (76 mm) Dimensions show recommended spacing allowed, except for closet door ventilation openings which are minimum required. [. . . ] Consider allowing more space for ease of installation and servicing, and spacing for companion appliances and clearances for walls, doors, and floor moldings. add spacing of 1" (25 mm) on all sides of washer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required. Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. To order, please see toll-free phone numbers in your Use and Care Guide. Top of laundry tub must be at least 39" (990 mm) above floor; install no higher than 96" (2. 5" (114 mm) of drain hose should be inside standpipe or below the top of wash tub. 3 ELECTRICAL REQUIREMENTS INSTALLATION INSTRUCTIONS Before you start: remove shipping materials It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. It is recommended that a separate circuit breaker serving only this appliance be provided. Clear water lines For floor drain installations, you will need to remove the drain hose form from the end of the drain hose. Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to avoid clogs. Make note of which hose is connected to hot water to help in attaching hoses to washer correctly. CONNECT INLET HOSES Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). NOTE: Both hoses must be attached and have water flowing to inlet valves. If you are only connecting to a cold water faucet, you must use a Y-adapter (not provided). IMPORTANT: To reduce risk of hose failure, replace the hoses every 5 years. n Periodically inspect and replace hoses if bulges , kinks , cuts , Attach hose to hot water faucet. IMPORTANT: Do not overtighten or use tape or sealants on valve when attaching to faucets or washer. [. . . ] 5" (113 (114 mm) Models with metal feet Jam nut or Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with cable tie. Check levelness of washer Place level here Place level here If washer is not level: On models with metal feet, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts clockwise on feet until they are about 1/2" (13 mm) from the washer cabinet. Then turn the leveling foot clockwise to lower the washer or counterclockwise to raise the washer. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WTW8500BC




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WTW8500BC will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.