User manual WHIRLPOOL WRF540CWBM WARRANTY INFORMATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WRF540CWBM. We hope that this WHIRLPOOL WRF540CWBM user guide will be useful to you.


WHIRLPOOL WRF540CWBM WARRANTY INFORMATION: Download the complete user guide (93 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WRF540CWBM ENERGY GUIDE (118 ko)
   WHIRLPOOL WRF540CWBM DIMENSION GUIDE (156 ko)
   WHIRLPOOL WRF540CWBM USE & CARE GUIDE (1539 ko)

Manual abstract: user guide WHIRLPOOL WRF540CWBMWARRANTY INFORMATION

Detailed instructions for use are in the User's Guide.

[. . . ] COMPONENT DESCRIPTION ELECTRICAL SEQUENCE: OPERATION: Water COMPONENT DESCRIPTION: Control Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . OPERATION: Refrigeration . SANITIZING AND CLEANING MAINTENANCE: Air Cooled SERVICE DIAGNOSIS: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING: Auger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls REMOVAL AND REPLACEMENT: Auger REMOVAL AND REPLACEMENT: Bearing And Breaker . REMOVAL AND REPLACEMENT: Fans LIQUID CHARGING . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Drain the water reservoir and freezer assembly using the drain tube attached to the freezer water inlet. Return the drain tube to its normal upright position and replace the end cap. Prepare the cleaning solution: Mix eight ounces of Scotsman Ice Machine Cleaner with three quarts of hot water. A possible sanitizer solution may be obtained by mixing two gallons of warm (90-115oF. ) potable water with 1 ounce of household bleach. Slowly pour the sanitizer solution into the water reservoir until the float rises, then switch the master switch ON. As the ice machine uses water from the reservoir, continue to pour the sanitizer solution into the reservoir. After 1/2 of the sanitizer solution has been added to the reservoir, and the reservoir is nearly empty, switch the master switch OFF. Drain the reservoir and thoroughly wash the interior of the reservoir and cover with sanitizer solution. Continue ice making for at least 15 minutes, to flush out any cleaning solution. Add warm water to the ice storage bin and thoroughly wash and rinse all surfaces within the bin. Sanitize the bin interior by thoroughly washing the interior of the bin and bin door with the balance of the sanitizer solution. Loosen band clamp under ice chute, and remove ice chute from evaporator. Drain the evaporator by lowering and uncapping the evaporator drain hose. After the auger has been removed, allow the auger to dry: if the auger is not bright and shiny, it must be cleaned. Reverse to reassemble. January 1995 Page 19 NME950 & WRF540CWBM SERVICE DIAGNOSIS: Symptom No ice is made, nothing operates Possible Cause Unit off due to no power Unit off due to master switch in OFF position. Check/clean ice level sensors. Unit off due to ice level sensors (photo-electric eyes) blocked. Check for water interruption (water cooled) or fan motor failure (air cooled). Check, replace board Check, replace sensor Check/replace contactor Low pressure control open No ice, auger motor is turning Check start capacitor. Check start relay Check compressor windings Circuit board compressor relay Check, replace board will not close. High discharge pressure Clean the air filter and because of a dirty condenser condenser. Low capacity because the Clean the water system auger and evaporator are coated with mineral scale Low suction pressure due to Locate leak. Recover low refrigerant charge refrigerant, repair leak, replace dryer, evacuate and weigh in the nameplate charge January 1995 Page 20 Centrifugal switch in auger motor does not close. [. . . ] It is · HP62 is not compatible with mineral oil, so these ice machines use Polyolester oil. When one of these refrigeration systems is opened for service, it must be re-sealed as soon as possible (15 minutes maximum). · Special leak detection equipment is required to locate small refrigerant leaks. Usually a leak detector capable of detecting a Halongenated refrigerant or HFC-134a will work. Access Valves: To use the access valves: · Remove the cap from the stem, use a 3/16" allen wrench to check that the valve is CLOSED. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WRF540CWBM




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WRF540CWBM will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.