User manual WHIRLPOOL KRDD 9010 INSTALLATION

[. . . ] Scrap the appliance in compliance with local regulations on waste disposal, taking it to a special collection centre; do not leave the appliance unattended even for a few days, since it is a potential source of danger for children. For further information on the treatment, recovery and recycling of this product, contact your competent local office, the household waste collection service or the shop where you purchased the appliance. The refrigerant circuit contains R134a (HFC) or R600a (HC) (see the rating plate inside the appliance). Appliances with Isobutane (R600a): isobutane is a natural gas without environmental impact, but is flammable. [. . . ] • Do not eat ice cubes or ice lollies immediately after taking them out of the freezer since they may cause cold burns. USE • Before carrying out any maintenance or cleaning operation, unplug the appliance or disconnect it from the power supply. • All appliances equipped with an automatic icemaker and water dispenser must be connected to a water supply that only delivers drinking water (with mains water pressure of between 0. 17 and 0. 81 Mpa (1. 7 and 8. 1 bar)). Automatic ice-makers and/or water dispensers not directly connected to the water supply must be filled with drinking water only. • Use the refrigerator compartment only for storing fresh food and the freezer compartment only for storing frozen food, freezing fresh food and making ice cubes. • Do not store glass containers with liquids in the freezer since they may burst. The Manufacturer declines any liability if the above advice and precautions are not respected. • Make sure the voltage specified on the rating plate corresponds to that of your home. • For the water connection, use the pipe supplied with the new appliance; do not reuse that of the previous appliance. • Power cable modification or replacement must only be carried out by qualified personnel. • It must be possible to disconnect the appliance from the power supply by unplugging it or by means of a mains two-pole switch installed upstream of the socket. 5 Installation • Install the appliance away from heat sources. Direct exposure to sunlight or installation near heat sources (radiators, cookers) will increase energy consumption and should therefore be avoided. To reactivate the refrigerator, press the same button (1) for 3 seconds. 7 Using the product Appliance’s alarms Open drawer alarm (upper draw only). The acoustic alarm will activate when the upper drawer has been left open. To completely deactivate the drawer open alarm, close the refrigerator drawer. Temperature alarm An increase in temperature inside the appliance, over +15°C, with the drawers closed, will cause the alarm to sound and a red warning LED (5) to flash. Pressing the Acoustic Alarm button (6), the alarm sound will silence, but the LED will continue flashing until the temperature decreases to the correct conservation temperature. Antibacterial filter alarm If on opening the drawer, the letters “AF” appear on the display (2), the antibacterial filter needs replacing (see section “Maintenance and cleaning”). To deactivate this alarm press the Acoustic Alarm button (6) for 5 seconds. Maintenance and cleaning Before carrying out any cleaning or maintenance operation, switch the product off by pressing button (1) on the control panel for 3 seconds, then unplug the appliance or disconnect it from the power supply. Cleaning the refrigerator Refrigerator defrosting is completely automatic. Droplets of water on the back wall behind the drawer, indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates Clean the defrost water drain hole regularly using the tool supplied, in order to ensure the constant and correct flow of defrost water. Important: • The vertical glass separators inside the drawers are part of the structure and should not be removed. [. . . ] (refer to “Maintenance and cleaning”). 10 Troubleshooting guide 4. The red light on the control panel remains on and/or the acoustic alarm is activated. • The light and alarm are activated for the following reasons: 1. Temperature alarm (red light on and acoustic signal activated) - Large amounts of fresh food have recently been placed in the product. [. . . ]