User manual WHIRLPOOL GXW7336DX

[. . . ] Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. discard fan or return to an authorized service facility for examination and/or repair. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. [. . . ] Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. Excessive Weight Hazard Use two or more people to move and install range hood. Installations using telescoping upper and lower vent cover assembly 1. Tape template in place, aligning the template centerline and bottom of template with hood bottom line and with the centerline marked on the wall. Determine and make all necessary cuts in the wall for the vent system. Run the home power supply cable according to the National Electrical Code or CSA Standards and local codes and ordinances. There must be enough ½" conduit and wires from the fused disconnect (or circuit breaker) box to make the connection in the hood's electrical terminal box. If there is no wood to screw into, additional wall framing supports may be required. Using 2 or more people, hang range hood on 2 mounting screws through the mounting slots on back of hood. Assemble the air deflector with the duct cover bracket with 2 - assembly screws provided with the Recirculation Kit. Measure from the bottom of the air deflector to the bottom of the hood outlet. Reassemble the air deflector to the duct cover bracket with 2 assembly screws. Run home power supply wiring through ¹/" strain relief into terminal box. Connect green (or bare) ground wire from home power supply to the 2 yellow-green ground wires (D) in terminal box using UL listed wire connectors. When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 2. NOTE: For vented installations, the upper vent cover may be reversed to hide slots. [. . . ] The cost of repair or replacement under these excluded circumstances shall be borne by the customer. If outside the 50 United States and Canada, contact your authorized Whirlpool dealer to determine if another warranty applies. If you need service, first see the "Troubleshooting" section of the Use & Care Guide. After checking "Troubleshooting, " you may find additional help by checking the "Assistance or Service" section or by calling Whirlpool. [. . . ]