User manual WHIRLPOOL GGG390LXS

[. . . ] We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING. You can be killed or seriously injured if you don't immediately follow instructions. [. . . ] A smaller size pipe on longer runs may result in insufficient gas supply. Usually, LP gas suppliers determine the size and materials used in the system. , flexible metal appliance connector may be used for connecting range to the gas supply line. 3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator. Do not kink or damage the flexible metal tubing when moving the range. Must include a shutoff valve: The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range opening, such as an adjacent cabinet. Gas supply pressure for testing regulator must be at least 1" water column pressure above the manifold pressure shown on the model/serial rating plate. Line pressure testing above ½ psi gauge (14" WCP) The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3. Line pressure testing at ½ psi gauge (14" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3. Excessive Weight Hazard Use two or more people to move and install range. Place them lengthwise on the floor behind the range to support the range when it is laid on its back. Using 2 or more people, firmly grasp the range and gently lay it on its back on the cardboard corners. Using 2 or more people, stand range back up onto cardboard or hardboard. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final location, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. Remove the anti-tip bracket that is taped inside the upper oven with the package containing literature. If you have a stone or masonry floor, you can use the wall mounting method. The mounting bracket can be installed on either the left side or right side of the cutout. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. [. . . ] If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. examples of a qualified person include: licensed heating personnel , authorized gas company personnel , and authorized service personnel. Failure to follow these instructions can result in death or serious burns to children and adults. Repeat steps 1 through 8 above for conversion of the upper oven bake burner. [. . . ]