User manual WHIRLPOOL AMD352

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AMD352. We hope that this WHIRLPOOL AMD352 user guide will be useful to you.


WHIRLPOOL AMD352 : Download the complete user guide (8733 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL AMD352 (8739 ko)
   WHIRLPOOL AMD352 (8737 ko)
   WHIRLPOOL AMD352 (8736 ko)
   WHIRLPOOL AMD352 (8739 ko)
   WHIRLPOOL AMD352 (8738 ko)
   WHIRLPOOL AMD352 (8740 ko)

Manual abstract: user guide WHIRLPOOL AMD352

Detailed instructions for use are in the User's Guide.

[. . . ] BEFORE USING THE APPLIANCE To make the most out of your new appliance, please read the user instructions carefully and keep them handy for future consultation. SAFETY PRECAUTIONS • The Installation and service/repair must be performed by a qualified technician, in compliance with the producer's instructions and following local safety norms. Do not repair or replace any parts of the appliance unless it is specifically written in the user instructions. • Do not pull the power supply cord to remove it from the socket. Do not twist or press the power supply cord, and make sure it is not broken. [. . . ] Front panel temperature display will change accordingly when turning on the appliance. Factory setting is based on °C EMERGENCY OPERATION Under emergency situation or when remote control is missing, you can control the unit by pressing the on/off swith located on the indoor unit. • Turn on the appliance: when the unit is off, press this button, it will start up and operate in 6th SENSE mode. • Turn off the appliance: when the unit is on, press this button, the unit will stop working. on/off switch PROTECTION Operating condition The protective device maybe trip and stop the appliance in the cases listed below. Outdoor air temperature is over 24°C Outdoor air temperature is below -7°C Room temperature is over 27°C Outdoor air temperature is over *43°C Cooling Room temperature is below 21°C Dehumidifying Room temperature is below 18°C Heating Noise pollution • Install the appliance at a place that can bear its weight in order to operate more quietly • Install the outdoor unit at a place where the air discharged and the operation noise would not disturb your neighbours. • Do not place any obstacles in front of the air outlet of the outdoor unit lest it increases the noise level. Features of protection device Wait at least 3 minutes before restarting the unit after operation stops or changing mode during operation. After connecting to power supply and turning on the appliance immediately, a delay of 20 seconds may occur before it starts to operate. Features of COOLING mode Anti-freezing When the temperature of the indoor heat exchanger drops to 0° or below, compressor will stop working to protect the appliance. Features of HEATING mode Preheating In order to prevent cool air blowing, 2-5 minutes are necessary to preheat the indoor unit at HEATING operation start. Defrosting In HEATING operation the appliance will defrost (de-ice) automatically to raise efficiency. During defrosting, fan stops running and "H1" will display on front panel. After defrosting is completeed, it returns to HEATING mode automatically. 41 MAINTENANCE Clean front panel of Indoor Unit 1. Disconnect from the power supply Turn off the appliance first before disconnecting from power supply. Remove the front panel Open the front panel as shown by the arrow (Fig. Pull the slots at the side of the front panel with force to take out the front panel (Fig. Use lukewarm water (below 40°C) to clean if the appliance is very dirty. Note: • Do not use substances such as gasoline or polishing powder to clean the appliance. B Clean Air filter It is necessary to clean the air filter after using it for about 100 hours. Clean the air filter every two weeks if the air conditioner operates in an extremely dusty environment. Disconnect from the power supply Turn off the appliance first before disconnecting from power supply. D) If the filter is very dirty, clean it with a solution of lukewarm water and neutral detergent. Note: • To avoid injury, do not touch the fins of indoor unit with your fingers after removing the filter. [. . . ] 3) Secure the power connecting cord on the control board with cable clamp. NOTE: (depending on the model) It is necessary to remove the cabinet to perform connections with the indoor unit terminal. INVERTER 9K/12K/18K Covering plate Power Connection Cable ON/OFF 9K/12K/18K Blue Black Brown Yellow Green Power connection cable Yellow Green Blue Black Violet Orange Cable Clamp Cable Clamp Power connection cable Defrost Cable • Outdoor Unit 1) Remove the access door from the unit by loosening the screw. Connect the wires to the terminals on the control board individually in accordance with the indoor unit connection. 2) Secure the power connecting cord on the control board with cable clamp. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AMD352




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AMD352 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.