User manual WHIRLPOOL AKR 806

[. . . ] Si les instructions d'installation du dispositif de cuisson gaz indiquent une distance suprieure, il est ncessaire de la respecter. AVERTISSEMENT : Coupez l'alimentation secteur avant de procder au branchement lectrique de la hotte. AVERTISSEMENT : Vrifiez si le conduit d'vacuation et les colliers de fixation sont fournis avec l'appareil. Remarque : Les pices portant le symbole "(*)" sont des accessoires en option fournis seulement avec certains modles ou sont des pices non fournies, acheter part. [. . . ] All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Do not leave pans unattended when frying, since the cooking oil could catch fire. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. 5019 318 33271 D GB F NL E P I GR The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. Is the lamp correctly fitted? 5019 318 33271 D GB F NL E P I GR DESCRIPTION OF HOOD A. Support bracket with cables and hooking brackets Hood fitted (motor + lights assembly) Cover Grease filter Carbon filter Carbon filter fixing elements Control rod Bottom halogen lamps Halogen lamps (top) 5019 318 33271 D GB F NL E P I GR Material supplied Remove all the components from the packets. Support bracket Cover Assembly template Filter/s Instruction manual 1 - adapter Torx T10 1 - adapter Torx T20 3 - plugs 10 x 60 mm 3 - screws 6 x 70 mm 5 - screws 3. 5 x 6. 5 mm 6 - screws 2. 9 x 9. 5 mm Installation dimensions 70 cm (gas or combi cookers) 50 cm (electric cookers) Cooktop surface 5019 318 33271 D GB F NL E P I GR INSTALLATION - ASSEMBLY INSTRUCTIONS The hood is designed for operation in filter version only: the air is filtered through a carbon filter and recycled in the room. The hood is supplied with fixing plugs suitable for most types of walls/ceilings. [. . . ] Deactivation of carbon filter saturation signalling (for particular applications) Switch off the hood (refer to section "Extraction speed (power) control") Press (prolonged for more than 5 seconds) the "extraction power selection" button; the LED flashes GREEN to indicate that carbon filter saturation signalling has been deactivated. To reactivate carbon filter saturation signalling, repeat the operation, and the LED will flash ORANGE (amber). 5019 318 33271 D GB F NL E P I GR PRODUCT SHEET Fitting the carbon filter: 1. Control panel Grease filter Bottom light Top light Support cables Interconnection cable Cover 1. GU4 12V - 35mm - 30 - Dichroic, taking care not to touch them with hands. [. . . ]