User manual WHIRLPOOL AKR 799

[. . . ] D INSTALLATION UND GEBRAUCH Der Mindestabstand zwischen dem Kochfeld und der unteren Kante der Dunstabzugshaube MUSS bei Elektroplatten 50 cm und bei Gas- oder kombinierten Herden 65 cm betragen. berprfen Sie vor der Installation auch die im Handbuch des Kochfeldes angegebenen Abstnde. Die Installation der Abzugshaube muss von einer Fachkraft ausgefhrt werden. Schlieen Sie das Gert erst nach seiner kompletten Installation an das Stromnetz an. [. . . ] Odmieta sa akkovek zodpovednost' za prpadn problmy, skody alebo poziare spsoben spotrebicom, vyplvajce z nedodrzania pokynov uvedench v tomto nvode. H ZEMBE HELYEZS S HASZNLAT A konyhai elszv legalacsonyabb rsze s a fzberendezsen kialaktott ednyfellet kztti tvolsgnak elektromos tzhely esetn legalbb 50 cm, gz- vagy vegyes tzhely esetn pedig legalbb 65 cm NAGYSGNAK KELL LENNIE. Packing Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. WARNING: To reduce the risk of accidents, electric shock, injury or damage, when using the hood comply with the basic precautions, including the following. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. Installation must be carried out by a specialised technician, in compliance with the manufacturer's instructions and local safety regulations. The electrical components must no longer be accessible to the user after installation. Do not touch the hood with wet parts of the body or use it when barefoot. After-sales service do not repair or replace any part of the hood unless specifically indicated in the manual. All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. [. . . ] The 2 modes are activated cyclically by pressing button "4". During cooking, the system promptly reacts to Steam/Gas increases and remains at the set speed for at least 1 minute, before returning to the lowest speed/switching off. 1. Increase speed / Speed timing Press the button and the hood goes from OFF to speed 1. Press the button (hood ON) to increase the motor speed from speed 1 to intensive. [. . . ]