User manual WESTINGHOUSE W32701

[. . . ] Westinghouse Digital 2004 27" Wide-Format LCD-TV User's Manual 27" Wide-Format LCD-TV User Manual Preface This manual is designed to assist you in setting up and using your LCD-TV. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. This document contains proprietary information protected by copyright. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission permission of Westinghouse Digital Electronics. [. . . ] button on the remote controller to adjust the default of that item. 5. Press MENU again to quit the picture. Menu DISPLAY CONTRAST BRIGHTNESS COLOR HUE SHARPNESS NOISE FILTER RESET < / > OFF 42 28 25 25 4 Descriptions Press to increase or decrease the picture contrast . Press to make picture brighter or darker. Contrast Brightness Color Temp Press to select color temps. For TV/S-VIDEO/AV/SCART Red Press to increase or decrease the red of the picture. Press to increase or decrease the blue of the picture. Green DISPLAY CONTRAST BRIGHTNESS COLOR-TEMP RED GREEN BLUE WHITE BALANCE RESET < / > USER 128 128 128 43 49 Blue In the PC Mode, select all white for the White Balance center ofpicture; and then press to make the color balanced. to make the picture sharper or For PC Hue Sharpness DISPLAY CONTRAST BRIGHTNESS COLOR HUE SHARPNESS FOCUS RESET < / > 42 35 46 27 4 15 Noise Filter Press to choose on or off to make the picture more clear. to make the signal sharper or Focus Reset< / > Press this button to restore all setups of the Display to the default. For YPbPr1/YPbPr2/D4 23 27" Wide-Format LCD-TV User Manual TV TV CCD V-CHIP CHANGE PASSWORD CH SCAN CATV / AIR CH ADD/DEL CABLE + OFF 1. Press button on the remote controller to select the main item (TV) to be adjusted. Press button on the remote controller to adjust the setup of that item. Press button on the remote controller to adjust the default of that item. Press MENU button again to quit the picture. Descriptions CCD (This function is designed for American NTSC system only) Use this function to activate the subtitle function. V-CHIP (grading system) (This function is designed for American NTSC system only) Enter password to activate the MENU of V-CHIP. You can press button to select the grade you want; and then press button to set up if you'd like to watch the programs. (Please refer to Table 1 and Table 2 as follows) Change Password (change the password for grading)(This function is designed for American NTSC system only) Press button and enter the original password (defaulted as 0000). CH Scan (automatic channel scanning) At CH Scan, press button to execute the automatic channel scanning. You need to execute the automatic channel scanning if you install your LCD display for the first time. CATV / AIR (TV signal source) Antenna Cable Press button on the remote controller to select the item you'd like to use. CH ADD/DEL Press button on the remote controller to select the item you'd like to +(ADD) / - (DEL) the channel. TV RATING V-CHIP MPAA-RATING G U PG U FV U PG-13 U R U NC-17 U L U U U X U D U U Y7 PG 14 MA FV D L S V suitable for older kids parental guidance required parents should be aware if the programs are suitable for children adults only fantasy and violence some sexual content and dialogue low level of content and profanity Sex Violence TV-RATING V S U U U U U U TV-Y7 TV-PG TV-14 TV-MA (Table 1) MAPP RATING B prohibited (not allowed to watch this program) U not prohibited (allowed to watch this program) suitable for children and average audience G parental guidance required PG PG-13 suitable for kids less than 13 years under parental supervision rated, children under 17 should be R accompanied by parents NC-17 children under 17 are not allowed X former grading, has merged with NC-17, but can be seen in older movies. 24 27" Wide-Format LCD-TV User Manual Geometric GEOMETRIC CLOCK PHASE H-POSITION V-POSITION RESET < / > 127 11 125 30 1. Press button on the remote controller to select the main item (Geometric) to be adjusted. button on the remote controller to select the item you'd like to adjust. button on the remote controller to adjust the default of that item. 5. Press MENU button again to quit the picture. Menu Descriptions Clock Press button to adjust the alignment of VGA for steady display of VGA. [. . . ] Hold the apparatus with two hands at the base of the panel when moving it. Caution: To reduce the risk of electric shock, do not remove cover (or back). Refer servicing to qualified service personnel. 33 27" Wide-Format LCD-TV User Manual 1) Read these instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ]