User manual THUNDER TIGER PHOENIX BX RTR PARTS CATALOG

[. . . ] appliance, switch power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. ~ b) Before servicing or cleaning the ~ This appliance is intended for ~ This appliance complies with current safety requirements. [. . . ] Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Cleaners are available from Miele. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the ventilation system. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Water could penetrate the electronics and cause damage. 12 Cleaning and Care Special instructions for control buttons The controls may change or become discolored if not cleaned regularly, clean soiled areas immediately. ^ Press and hold the 0/1 button until the fan turns off. Do not use a stainless steel cleaner on the controls. Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). The grease filters should be cleaned every 3 - 4 weeks, otherwise cleaning will become more difficult. ^ At the upper edge, push the grease filter down until you can pull it forward, then up and out. The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information. 18 Caring for the environment Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. Before installation, please read the "Appliance dimensions" and "Important safety instructions". Installation preparation ^ Remove the side screws at the top of the housing, put the top mounting brackets in place and screw them into place. ^ Screw the bottom mounting brackets to the side of the housing using 2 screws each. Attach them with mounting clip "A" pointing up. ^ Remove the connection plate from the front of the appliance. ^ Alternatively the bracket can be attached to the front of the appliance. Use the housing screws which were initially removed. 26 Installation Alternatively, or additionally, the appliance can also be attached underneath the countertop with the angle brackets provided. ^ First, loosely screw the brackets into the sliding nuts in the housing, then push them up under the countertop. ^ Carefully pre-drill the mounting holes into the countertop from underneath. Using screws of the appropriate length. ^ With the assistance of another person, lift the appliance into the prepared cutout. The top mounting brackets should rest on the countertop. ^ Level and align the appliance. ^ Push the bottom mounting bracket on each side down against the cabinet floor. Mark the top edge of the mounting bracket on the housing and the mounting holes on the cabinet floor. 27 ^ Secure the appliance to the countertop with 2 screws. Installation ^ Remove the screws from the countertop. [. . . ] Exhaust ducting and connections ­ The ducting should be as short and straight as possible, and the number of sharp bends should be minimized. ­ For most efficient air extraction, the diameter of the ductwork should not be less than 6" (150 mm)*. ­ Noise levels of the ventilation system will increase if flat ducts or round ducts of less than 6" (150 mm)* in diameter are used. ­ Use smooth or flexible pipes made from approved non-flammable materials for exhaust ducting. [. . . ]