User manual SUNBEAM 4239

[. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. ­ If you have any question regarding this warranty or would like to obtain warranty service, please call 1. In Canada ­ If you have any question regarding this warranty or would like to obtain warranty service, please call 1. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. [. . . ] The Fabric Select Dial and Steam Lever should always be turned to OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. To protect against risk of electric shock, do not immerse the iron in water or other liquids. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. Take it to an authorized service center for examination and/or repair. Incorrect reassembly can cause a risk of electric shock when the iron is used. Always disconnect iron from electrical outlet when filling with water, cleaning or emptying and when not in use. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while plugged in or turned on or on an ironing board. If the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center. Use caution when you turn a steam iron upside down ­ there may be hot water in the reservoir. The Power Indicator will blink to let you know that the iron has stopped heating. ⷠIn a vertical position (on its heel rest) without moving it, the iron will automatically turn off after 15 minutes. The Power Indicator will blink to let you know that the iron has stopped heating. iMPORTANT: The Power Indicator will continue to blink until the iron is unplugged or reset. TO RESET THE IRON: Move the iron back and forth and allow it to reheat for 2 minutes. the indicator will stop blinking and the iron will start heating again. WARNING: Motion Smart® Auto-Off is a safety feature, not a recommended means for turning your iron off. See "Caring for Your Iron After Use" for information on turning off your iron and storing it safely between use. STORAGE STRIPTM INDICATOR (select models only) is an easy way to see when the iron is cool enough to store. In approximately 2 minutes, the STORAGE STRIPTM INDICATOR will turn from black to red, indicating that the iron is too hot to store. When the iron is turned off, it will take the iron approximately 30-40 minutes for the STORAGE STRIPTM INDICATOR to turn from red to black, indicating that the iron is cool enough to store. [. . . ] Do not allow children to use retractable cord feature as the cord may cause injury. If you do not use your iron on a daily basis, empty the water reservoir after each use for a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole cover, and allow water to flow from the fill hole. If your iron does not have a retractable cord, loosely loop the power cord around the heel rest and store the iron on its heel rest. [. . . ]