User manual SONY VPL-CS7

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Caution use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] For stereo equipment, use both the L and R jacks; for monaural equipment, use the L (MONO) jack only. iNPUT A (HD D-sub 15-pin , female): Connects to the monitor output on a computer using the supplied cable. The volume of the speakers can be controlled by the VOLUME keys on the Remote Commander or the control panel. The keys which have the same names as on the control panel function identically. 1 I / u key 2 INPUT key 3 LASER key Emits laser beam from the laser transmitter when you press this key. 4 Joy stick Functions as a mouse of a computer connected to the unit. 5 Arrow keys (V/v/B/b) 6 R CLICK key Functions as a right button on a mouse. When connected to a Macintosh1) computer, the R CLICK key functions as a mouse button. 7 RESET key 8 VOLUME +/­ keys 9 Strap holder Attaches the supplied strap. º CONTROL S OUT jack (stereo minijack) This jack does not operated with this unit. The Remote Commander does not function if the cable is connected to this jack. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. Supplied mouse cables may not work properly according to your computer. When connecting with an IBM PC/AT compatible computer When connecting with a Macintosh computer To audio out to monitor out This section describes how to connect the projector with a VCR, external active speakers, and component equipment. When making connections, be sure to: · Turn off all equipment before making any connections. Insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. 1) When both the S VIDEO and VIDEO jacks are connected to the external equipment, the input signal from the S VIDEO jack is selected. The projector is equipped with an on-screen menu for making various adjustments and settings. About the memory of the settings When there is no input signal, the screen turns blue and "NO INPUT­Cannot adjust this item. Select an item Use the V or v key to select the item, then press the b or ENTER key. When changing the adjustment level: To increase the number, press the V or b key. [. . . ] When you replace the lamp, wait for at least an hour for the lamp to cool. If you use lamps other than LMP-600, the projector may cause a malfunction. Be sure to turn off the projector and unplug the power cord before replacing the lamp. Do not place the old lamp near children or near the objects which catch fire easily. [. . . ]