User manual SONY SRS-BTD70

[. . . ] The POWER indicator (green) flashes three times when the volume is set to minimum or maximum. (Bluetooth) indicator (blue) Lights up or flashes depending on the communication status. For details, see the following section, “Indications of the Bluetooth function. ” POWER indicator (green) Lights up when the system is turned on. [. . . ] To avoid damaging the system, do not use any other AC adaptor. Indications of the Bluetooth function Polarity of the plug  Plug the AC adaptor into a nearby wall outlet (mains). In the case of a problem, unplug it from the wall outlet (mains) immediately.  Do not install the AC adaptor in a confined space, such as a bookcase or built-in cabinet.  To reduce the risk of fire or electric shock, do not expose the AC adaptor to dripping or splashing, and do not place objects filled with liquids, such as vases, on the AC adaptor. Status Pairing with a device Searching for a device Connected to a device AUDIO IN mode (Bluetooth) indicator (blue) Flashes quickly Flashes Lights up Off The indicator lights up. 5 Select “SRS-BTD70” shown in the display of the Bluetooth device. Listening to Music by Wired Connection with a Portable Audio Device, etc. 1 Connect the device to the system. On Copyrights and Licenses 6 If Passcode* input is required on the display of the Bluetooth device, input “0000. ” The Bluetooth connection is completed and the (Bluetooth) indicator (blue) on the system stays on. * Passcode may be called “Passkey, ” “PIN code, ” “PIN number, ” or “Password. ” The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. Other trademarks and trade names are those of their respective owners. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. On placement  Do not set the speaker in an inclined position.  Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock.  Do not expose the battery to excessive heat such as direct sunlight, fire or the like. To use with LR6 (size AA) batteries (not supplied) 1 Press  and slide the cover. 7 Start playback on the Bluetooth device, then adjust the volume. Set the volume of the Bluetooth device to a moderate level, and press the VOLUME –/+ buttons on the system. Connecting cord (supplied) Tip  To pair with other Bluetooth devices, repeat steps 2 to 6 for each device. On operation Notes  Do not insert any small objects, etc. , into the jacks or ventilation hole on the rear of the system. The system may short out or malfunction. On cleaning Others 2 Install three LR6 (size AA) batteries (not supplied), then close the cover.  Do not use alcohol, benzine, or thinner to clean the cabinet.  If you have any questions or problems concerning this system that are not covered in this manual, please consult your nearest Sony dealer. 3 Turn the POWER switch to ON. Tip  If the AC adaptor is used with the system, the power source switches to power from the wall outlet (mains) automatically, even if batteries are installed.  Pairing mode of the system is cancelled after about 5 minutes, and the (Bluetooth) indicator (blue) turns off. If the pairing mode is cancelled while performing this procedure, start over from step 3.  Passcode of the system is fixed as “0000. ” The system cannot be paired with a Bluetooth device whose Passcode is not “0000. ”  Once Bluetooth devices are paired, there is no need to pair those devices again. However, in the following cases, you will need to perform the pairing procedure again. [. . . ]  A device featuring the Bluetooth function is required to conform to the Bluetooth standard specified by Bluetooth SIG, and be authenticated. Even if the connected device conforms to the above mentioned Bluetooth standard, some devices may not be connected or work correctly, depending on the features or specifications of the device.  Noise or sound skips may occur depending on the Bluetooth device connected with the system, the communication environment or the usage environment. DC 5. 2 V (when using the supplied AC adaptor connected to AC 100 V - 240 V power supply) Three LR6 (size AA) batteries Rated power consumption 1. 8 W (when using the supplied AC adaptor) Approx. [. . . ]