User manual SONY CDX-S2000C

[. . . ] * Not available for this unit Note If the display disappears by pressing (OFF), it cannot be operated with the card remote commander unless (SOURCE) on the unit is pressed, or a disc is inserted to activate the unit first. Before playing, clean the discs with a commercially available cleaning cloth. You can play CD-Rs (recordable CDs)/CDRWs (rewritable CDs) designed for audio use on this unit. Such discs may stop spinning when used, causing a malfunction, or may ruin the disc. [. . . ] The unit stores stations in the order of their frequencies on the number buttons. If only a few stations can be received due to weak signals, some number buttons will retain their former settings. When a number is indicated in the display, the unit starts storing stations from the one currently displayed. Press the number button ((1) to (6)) on which the desired station is stored. During radio reception, press (SENS) (BTM) repeatedly until "MONO-ON" appears in the display. You can manually preset the desired stations on any chosen number button. If the automatic tuning stops too frequently, press (SENS) (BTM) repeatedly until "LOCAL-ON" appears in the display. Press the desired number button ((1) to (6)) for 2 seconds until "MEM" appears. Tip If you know the frequency of the station you want to listen to, press and hold (SEEK) (+) or (SEEK) (­) to locate the approximate frequency, then press (SEEK) (+) or (SEEK) (­) repeatedly to fine adjust to the desired frequency (manual tuning). Note If you try to store another station on the same number button, the previously stored station will be erased. FM stations with Radio Data System (RDS) service send inaudible digital information along with the regular radio programme signal. For example, one of the following will be displayed upon receiving a station with RDS capability. The AF function allows the radio to always tune into the area's strongest signal for the station you are listening to. The unit starts searching for an alternative frequency with a stronger signal in the same network. Receiving traffic announcements, even when enjoying another programme/source. Depending on the country/region, not all of the RDS functions are available. RDS will not work properly if the signal strength is too weak or if the station you are tuned to is not transmitting RDS data. If you want to change the on/off setting while playing a CD, press (AF). When there is no alternative frequency in the area or when you do not need to search for one, turn the AF function off by selecting "AF-OFF. The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI SEEK" appears). If the unit cannot find the same PI, the unit returns to the previously selected frequency. These settings function regardless of the current FM programme/source, CD; the unit switches back to the original source when the bulletin is over. [. . . ] An optional power amplifier is connected and you are not using the built-in amplifier. The leads are not matched correctly with the car's accessory power connector. The following indications will flash for about 5 seconds, and an alarm sound will be heard. Connect a power aerial control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's aerial booster (only when your car has built-in FM/MW/ LW aerial in the rear/side glass). [. . . ]