User manual SMEG UKFC36RX

[. . . ] Loose frost may be removed carefully with a plastic or wooden scraper. When the layer of frost on the shelves is 5-10 mm the freezer should be defrosted. Note: The layer of frost on the front edge of the top freezing shelf may grow slightly thicker. [. . . ] Find the position of the thermostat which gives you the desired temperature. The refrigerator section Never store hot foodstuffs in the cabinet and remember always to wrap up the foodstuffs. The evaporator of the refrigerator section is automatically defrosted. The defrost water is led to a tray on top of the compressor where it evaporates. Temperature regulation: The slide damper above the crisper bin makes it possible to regulate both the temperature and the humidity in the crisper bins. l Closed slide damper increases the temperature and the humidity. 3 Fold out the draining spout, mount the enclosed extension and place a bowl under it, fig. Wipe the cabinet when the frost has disappeared. DISPOSAL OF THE APPLIANCE The appliance contains recyclable materials. When disposing of the appliance, please contact the technical administration or other appropriate authority in your municipality. They can inform you of the collection and recycling measures used in the municipality. 3. GENERAL ADVICE ON THE USE OF THE APPLIANCE The shelves in the refrigerator section can be moved, fig. Household appliances sold in the EU also meet 96/57/EEC (energy efficiency requirements) as amended. The rating plate, which is placed either at the back or inside the appliance, see fig. (7) page 7, provides various technical information as well as type and serial number. You should be aware of this when installing the appliance in weekend cottages or elsewhere where you would not immediately observe that the power has been cut off. Construction and details in the accessories are subject to alteration without previous notice. If the cabinet is to be adjusted: See drawings (1) page 6 Take hold of the front panel with both hands. Then lift up the front panel and turn out the bottom part. Adjust the tilt of the unit 8. Install the cabinet in a dry place and so that it is not exposed to direct sunlight or any other source of heat. This is easily achieved by adjusting the adjustable feet at the front edge of the base. When placing the cabinet on a carpet or on a wooden floor, the placing should be checked after a while to see whether the unit has , , subsided" into the soft flooring. KF models put side by side with other models require a distance of 2 inches between the appliances. [. . . ] For sufficient airflow around the cabinet it is necessary to have a 4inches high air duct right above the appliance, see fig. (2a) and (2b) or an air duct that leeds the air up over the top cupboard, see fig. Make sufficient space for door opening as to draw the baskets out, see fig. [. . . ]