User manual SIEMENS LF457CA60

[. . . ] Unrestricted operation is possible if the extractor hood is used in recirculating mode – with activated carbon filter. Circulating-air mode: ❑ An activated carbon filter must be fitted for this operating mode (see Filters and maintenance). The complete installation set and replacement filters can be obtained from specialist outlets.  The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen. [. . . ] The appliance may be connected to the mains by a qualified technician only. dispose of packaging materials properly (see Installation instructions). Defective bulbs should be replaced immediately to prevent the remaining bulbs from overloading. 13 ṇ ṇ ṇ ṇ ṇ ṇ ṇ Operating procedure The most effective method of removing vapours produced during cooking is to: ❑ Switch the ventilator ON as soon as you begin cooking.  Switch the ventilator OFF a few minutes after you have finished cooking. Intensive setting: Maximum power is obtained at the intensive setting.  Keep pressing the + button until a ç appears in the display.  If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes. The fan continues to run at step | for 10 minutes, and at the same time a dot flashes in the display. Lighting: ❑ The light can be switched on at any time, even though the fan is switched off. Light Display for fan setting Reduce fan speed Fan followon Fan ON and increase speed Intensive setting Fan OFF Acoustic signal: ❑ When a button is pressed, this is verified by an acoustic signal. 14 Filters and maintenance Grease filters: Metal filters are used to trap the greasy element of the vapours that develop during cooking. Caution: As the filter becomes more and more saturated with grease, not only does the risk of it catching fire increase but the efficiency of the extractor hood can also be adversely affected. Important: By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced. Saturation indicator: ~ When the grease filters becomes saturated, the display symbol # lights up and a signal sounds. Cleaning the metal grease filters: ❑ In normal operation (1 to 2 hours daily), the metal grease filter must be cleaned 1 x a month.  The filter must be placed loosely, and NOT wedged, in the dishwasher. Important: Metal filters that are saturated with grease should not be washed together with other dishes etc.  When cleaning the filters by hand, soak them in hot soapy water first of all. Then brush the filters clean, rinse them thoroughly and leave the water to drain off. Removing and inserting the metal grease filters: Warning: The halogen bulbs must be switched off and cool. Press the handles on the grease filters downwards and fold the grease filters down. [. . . ] This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency.  Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Clean the operating buttons with a mild 17 Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. [. . . ]