User manual SIEMENS KF 18 WA 41 IE

[. . . ] The more refrigerant an appliance contains, the larger the room must be in which the appliance is situated. Leaking refrigerant can form a flammable gas-air mixture in rooms which are too small. The amount of refrigerant in your appliance is indicated on the rating plate inside the appliance. – Important information when using the appliance ■ Never use electrical appliances inside the appliance (e. [. . . ] If you have any complaints, please contact the dealer from whom you purchased the appliance or our customer service. The delivery consists of the following parts: ■ ■ ■ ■ ■ ■ ■ ■ Built-in appliance Interior fittings (depending on model) Bag containing installation materials Operating instructions Installation manual Customer service booklet Warranty enclosure Information on the energy consumption and noises Note The appliance is fully functional within the room temperature limits of the indicated climatic class. If an appliance of climatic class SN is operated at colder room temperatures, the appliance will not be damaged up to a temperature of +5 °C. 17 en Cavity depth A cavity depth of 560 mm is recommended for the appliance. If the cavity depth is smaller – at least 550 mm – the energy consumption increases slightly. Electrical connection The socket must be near the appliance and also freely accessible following installation of the appliance. Connect the appliance to 220–240 V/50 Hz alternating current via a correctly installed socket with protective conductor. For appliances operated in nonEuropean countries, check whether the stated voltage and current type match the values of your mains supply. 7 Installation location Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: ■ ■ ã=Warning 3 cm to electric or gas cookers. Connecting the appliance After installing the appliance, wait at least 1 hour until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance (see chapter “Cleaning the appliance”). Mainscontrolled inverters are used for photovoltaic systems which are connected directly to the national grid. On ships or in mountain lodges) which are not connected directly to the national grid. 18 en Getting to know your appliance Switching on the appliance Switch on the appliance with the main On/Off switch. The appliance starts to cool, the light is switched on when the door is open. 1 1 2 3 4 5 Contact sensor Controls/light Bottle shelf Glass shelf Touch-Light door handle After the appliance has been switched on, it may take several hours until the set temperature has been reached. €super” button Is used to switch on the super cooling (see chapter entitled “Super cooling”). Temperature display The numbers correspond to the set refrigerator compartment temperatures in °C. Temperature selection button Press this button to set the temperature. [. . . ] Disconnecting the appliance If you do not use the appliance for a prolonged period: 1. Cleaning the appliance ã=Caution ■ ■ Do not use abrasive, chloride or acidic cleaning agents or solvents. – 21 en Tips for saving energy ■ Operating noises Quite normal noises Droning Motors are running (e. The appliance should not be installed in direct sunlight or near a heat source (e. [. . . ]