User manual SHARP XL-DH259N

[. . . ] Non togliere mai i coperchi, a meno di non essere qualificati per farlo. All'interno dell'apparecchio ci sono tensioni pericolose, per cui si deve sempre staccare la spina del cavo d'alimentazione dalla presa di corrente prima di qualsiasi intervento di manutenzione e quando non si usa l'apparecchio per un lungo periodo di tempo. Wanneer de ON/STAND-BY toets in de STAND-BY stand staat, loopt er nog steeds stroom (netspanning) in het toestel. Wanneer de ON/STAND-BY-knop in de STAND-BY-positie staat, kunt u het apparaat aanzetten met de afstandsbediening. Waarschuwing: Bei Einstellung der ON/STAND-BY-Taste auf STAND-BY ist die Netzspannung immer noch im Gerät vorhanden. [. . . ] Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than that which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. Volume control The sound level at a given volume setting depends on speaker efficiency, location, and various other factors. Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss. Controls and indicators Front panel Reference page 1. 29 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 Display 7 8 Reference page 1. 26 E-2 Controls and indicators (continued) Speaker system 2 3 1. Speaker Wire 1 1 Remote control ON / STAND-BY OPEN / CLOSE 2 3 1 4 7 2 5 8 0 TUNING 19 3 6 9 10 TUNING 4 5 6 7 8 9 10 11 12 13 14 15 DIRECT PRESET PRESET SETUP OSD FUNCTION EQUALIZER VOLUME X-BASS MEMORY MUTE 20 21 22 23 24 25 26 27 TOP MENU MENU/PBC ENTER SUB TITLE / DIGEST RETURN AUDIO ZOOM ANGLE 16 17 18 SLOW STEP RANDOM ASPM / PTY RDS DISP A-B 28 29 30 31 32 33 34 Reference page 1. 27, 28 E-3 Types of playable discs The DVD player can play back discs bearing any of the following marks: Disc type DVD Video Disc Disc contents Audio and video (movies) 2 Super Video CD Audio and video (movies) or 3 or 4 Icons used in this operation manual Some functions may not be available depending on discs. The following icons indicate the discs that can be used in the section. Some operations may not be performed depending on discs even if they are described in this manual. The audio recorded on the DVD can be switched by using the AUDIO button. The number of audio tracks and recording systems vary depending on the DVD. Check them in the DVD's manual. Audio CDs consist of "tracks". A "track" is each tune on an audio CD. Track 1 Track 2 Track 3 Track 4 Track 5 Note: Title, chapter, or track numbers may not be recorded on some discs. DivX® Official DivX CertifiedTM product. Plays all versions of DivX® video (including DivX® 6) with standard playback of DivX® media files. (DivX® version cannot be upgraded on this product. ) E-5 System connections Make sure to unplug the AC power lead before making any connections. 75 ohms coaxial cable External FM aerial FM aerial (commercially available) To audio input socket To component video input sockets (not supplied) To SCART input socket (not supplied) PB PR (supplied) To video input socket (not supplied) To HDMI input socket Wall socket (AC 220 - 240 V ~ 50/60 Hz) (commercially available) To S-video input socket To coaxial digital audio input socket (commercially available) Red (commercially available) Right speaker Left speaker Black To audio output sockets Aerial connection External FM aerial Supplied FM aerial: Connect the FM aerial wire to the FM ANTENNA 75 OHMS socket and position the FM aerial wire in the direction where the strongest signal can be received. Note: Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception. Use an external FM aerial if you require better reception. Note: When an external FM aerial is used, disconnect the supplied FM aerial wire. E-6 System connections (continued) Speaker connection AC power connection Connect the black wire to the minus (­) terminal, and the red wire to the plus (+) terminal. Caution: Use speakers with an impedance of 6 ohms or more, as lower impedance speakers can damage the unit. The right speaker is the one on the right side when you face the unit. [. . . ] Does the remote control sensor receive strong light? Before plugging in or unplugging the headphones, reduce the volume. Be sure your headphones have a 3. 5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. Adjust the volume using the VOLUME control. Symptom The remote control does not operate. Troubleshooting chart Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre. Tuner Symptom Possible cause Is the unit placed near the TV or computer? [. . . ]