User manual SHARP XL-HF151PHS

[. . . ] Avvertenza: L'apparecchio non contiene parti riparabili dall'utente. Non togliere mai i coperchi, a meno di non essere qualificati per farlo. All'interno dell'apparecchio ci sono tensioni pericolose, per cui si deve sempre staccare la spina del cavo d'alimentazione dalla presa di corrente prima di qualsiasi intervento di manutenzione e quando non si usa l'apparecchio per un lungo periodo di tempo. Wanneer de ON/STAND-BY toets in de STAND-BY stand staat, La societ SHARP ELECTRONICS EUROPE GmbH dichiara che il prodotto SHARP HI FI SISTEMI XL-HF151PHS e XL-HF200PH(BK) costruito in conformit alle prescrizioni del D. M. no 548 del 28/8/95, pubblicato sulla G. U. no 301 del 28/12/ 95 ed in particolare conforme a quanto indicato nell'art. 2, comma 1 dello stesso decreto. Bei Einstellung der ON/STAND-BY-Taste auf STAND-BY ist die Netzspannung immer noch im Gert vorhanden. [. . . ] Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than that which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. Please ensure that the equipment is positioned in a well ventilated area and ensure that there is at least 10 cm (4") of free space along the sides, top and back of the equipment. 10 cm (4") 10 cm (4") 10 cm (4") 10 cm (4") Use the unit on a firm, level surface free from vibration. Place the speakers at least 30 cm (12") away from any CRT TV to avoid colour variations across the TV screen. If the variations persist, move the speakers further away from the TV. Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generate electrical noise. Do not expose the unit to moisture, to temperatures higher than 60C (140F) or to extremely low temperatures. If your system does not work properly, disconnect the AC power lead from the wall socket. Hold the AC power plug by the head when removing it from the wall socket, as pulling the lead can damage internal wires. Volume control The sound level at a given volume setting depends on speaker efficiency, location, and various other factors. Excessive sound pressure from earphones and headphones can cause hearing loss. Controls and indicators 12 6 7 3 5 15 4 8 9 10 11 12 13 14 Front panel Page 10. 2 Insert the supplied batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them towards the () battery terminals. 3 Close the cover. Notes: No sound is heard from the subwoofer without a built-in amplifier. Subwoofer Pre-out (audio signal): 200mV / 10k ohms at 70 Hz. Connecting a TV, etc. To audio output sockets Connect to the TV using an audio cable. TV Audio cable (commercially available) Audio signal To LINE input sockets Caution: Replace all old batteries with new ones at the same time. Remove the batteries if the unit will not be used for a long period of time. Installing the batteries incorrectly may cause the unit to malfunction. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar). Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. [. . . ] Has condensation formed inside the unit? Remote control Symptom Possible cause Is the AC power lead of the unit plugged in? Does the remote control sensor receive strong light? Headphones Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss. Be sure your headphone has a 3. 5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. [. . . ]