User manual SHARP XL-DAB10NH

[. . . ] Avvertenza: L'apparecchio non contiene parti riparabili dall'utente. Non togliere mai i coperchi, a meno di non essere qualificati per farlo. All'interno dell'apparecchio ci sono tensioni pericolose, per cui si deve sempre staccare la spina del cavo d'alimentazione dalla presa di corrente prima di qualsiasi intervento di manutenzione e quando non si usa l'apparecchio per un lungo periodo di tempo. Wanneer de ON/STAND-BY toets in de STAND-BY stand staat, La societ SHARP ELECTRONICS EUROPE GmbH dichiara che il prodotto SHARP MICRO SISTEMI XL-DH320NH / XL-DAB10NH costruito in conformit alle prescrizioni del D. M. no 548 del 28/8/ 95, pubblicato sulla G. U. no 301 del 28/12/95 ed in particolare conforme a quanto indicato nell'art. 2, comma 1 dello stesso decreto. Bei Einstellung der ON/STAND-BY-Taste auf STAND-BY ist die Netzspannung immer noch im Gert vorhanden. [. . . ] 10 cm (4") 10 cm (4") 10 cm (4") MICRO COMPONENT SYSTEM XL-DH320 10 cm (4") Use the unit on a firm, level surface free from vibration. Place the speakers at least 30 cm (12") away from any CRT TV to avoid colour variations across the TV screen. If the variations persist, move the speakers further away from the TV. Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generate electrical noise. Do not expose the unit to moisture, to temperatures higher than 60C (140F) or to extremely low temperatures. If your system does not work properly, disconnect the AC power lead from the wall socket. Hold the AC power plug by the head when removing it from the wall socket, as pulling the lead can damage internal wires. Volume control The sound level at a given volume setting depends on speaker efficiency, location, and various other factors. Excessive sound pressure from earphones and headphones can cause hearing loss. Controls and indicators 1 Front panel Page 1. 9 2 3 9 4 5 6 7 8 MICRO COMPONENT SYSTEM XL-DH320 10 11 12 13 E-2 Controls and indicators (continued) 1 22 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 23 CD USB Remote control 24 25 26 27 28 29 30 31 32 33 34 35 36 1 2 3 4 5 6 7 8 9 10 Page 1. 4. Speaker system (CP-DH320NH) Tweeter Woofer Bass Reflex Duct Speaker Wire 1 2 3 4 Page 1. 4. Speaker system (CP-DH350NH) Tweeter Woofer Bass Reflex Duct Speaker Wire Speaker grilles are removable 1 2 3 4 Make sure nothing comes into contact with the speaker diaphragms when you remove the speaker grilles. Installing the batteries incorrectly may cause the unit to malfunction. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar). Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Keep the remote control away from moisture, heat, shock, and vibrations. To turn the power on Press the ON/STAND-BY button to turn the power on. After use: Press the ON/STAND-BY button to enter the power stand-by mode. Display brightness control To dim the display brightness, hold down the CLEAR/ DIMMER button on the remote control for 2 seconds or more. Volume auto fade-in If you turn off and on the main unit with the volume set to 27 or higher, the volume starts at 16 and fades in to the last set level. Volume control Turn the volume knob towards VOL +/ (on main unit) or press VOLUME +/ (on remote control) to increase or decrease the volume. X-Bass control Test of the remote control Check the remote control after checking all the connections. The remote control can be used within the range shown below: Remote sensor When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and "X-BASS" will appear. To cancel the extra bass mode, press the X-BASS button on the remote control. Bass control 1 Press the BASS/TREBLE button to select "BASS". 2 Within 5 seconds, press the VOLUME (+ or ) button to adjust the bass. Treble control 1 Press the BASS/TREBLE button to select "TREBLE". [. . . ] Does the remote control sensor receive strong light? The remote control does not operate. Headphones Tuner Symptom The radio makes unusual noises continuously. Move the aerial away from the AC power lead if it is located nearby. Do not turn the volume on to full at switch on and listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss. Be sure your headphones have a 3. 5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. [. . . ]