User manual SHARP XE-A217 QUICK START GUIDE

[. . . ] Please read this manual carefully before operating your machine in order to gain full understanding of functions and features. Be very careful when removing and replacing the printer cover, as the cutter mounted on it is very sharp. Install the cash register in a location not subject to direct sunlight, unusual temperature changes, high humidity or splashing water. The water could seep into the interior of the register and cause component failure. [. . . ] Key operation example The lowest taxable amount is valid only when you select add on tax system. If you make an incorrect entry before pressing the third @ key in programming a tax rate, cancel it with the l key. You do not need to enter the trailing zeros of the tax rate (after the decimal point), but you do need to enter the decimal for fractions. To delete a tax rate, use the following sequence: Merchandise can be classified into a maximum of 50 departments. Items sold using the department keys can later be printed on a report shown as the quantities sold and sales amounts classified by department. The data is useful for making purchasing decisions and other store operations. *To program departments 17 through 32, press the department shift key. To program another department, start from the beginning without pressing the A key. Taxable Non-taxable* Taxable Non-taxable* Taxable Non-taxable* Taxable* Non-taxable SICS Normal* Negative department Positive department* Open and preset Preset only Open only* Inhibit department key When any entry of a taxable department is made in a transaction, tax is automatically computed according to the associated tax rate as soon as the transaction is completed. If an entry of a department programmed for SICS is made first, the sale will be finalized as a cash sale as soon as the department key is pressed. If the entry is made after entering a department not programmed for SICS, the sale will not be finalized until the A key is pressed. Key operation example Print The register allows you to program text for clerk names, department item names, PLU/subdepartment item names, if necessary. There are two ways for programming text: using character keys on the keyboard or entering character codes with numeric keys on the keyboard. Using character keys on the keyboard You can enter characters according to the small figures printed in the lower right position of the tops. for the layout , please refer to "Keyboard" section on page 5. The following are used as control keys for character entry: H Toggles between upper-case and lower-case letters. Once the H key is pressed, you are locked in for entering lower-case letters. "_" lights up at the SHIFT position of the display when lower-case letters entry is selected. If you press the 1 key without pressing the N key, the cash register goes to character codes entry mode. Once the N key is pressed, you are locked in for entering numeric characters. "_" lights up at the NUMBER position of the display when numeric characters entry is selected. Once the W key is pressed, you are locked in for entering double size characters. [. . . ] Set the spool on the bearing, and press the key to take up excess slack in the paper. You can wind the roll paper in OP X/Z, X1/Z1, and X2/Z2 modes even if you programmed so that the printer is used for issuance of receipts. Never touch the print head immediately after printing, as the head may still be hot. Check for and remove any shreds of paper that may remain in the printer. [. . . ]