User manual SHARP SJ-W36/40J

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP SJ-W36/40J. We hope that this SHARP SJ-W36/40J user guide will be useful to you.


SHARP SJ-W36/40J : Download the complete user guide (1216 Ko)

Manual abstract: user guide SHARP SJ-W36/40J

Detailed instructions for use are in the User's Guide.

[. . . ] The deodorizing unit which requires no manual operation because it automatically starts operating when the refrigerator is powered on. Plasmacluster and low-temperature catalytic deodorizer will not operate since chilled air does not enter/exit the vegetable compartment. Mounting and removing accompanying parts Cleaning the refrigerator Cleaning the automatic ice maker Cooling panel (refrigerator compartment) Keeps compartment temperature uniform. The "indirect" cooling method of the cooling panel gently cools foods in a "wrapping" manner rather than cooling directly. "Direct" cooling air is discharged when newly placing foods for quick cooling. What to do Power outage Moving / Transporting Switching off your refrigerator When the compartment light is blown Automatic ice maker with Rapid Ice Making feature Door-open buzzer Troubleshooting Plasmacluster OUT related LCD panel related Automatic ice maker related When a door is left open, beeps will sound after 1 minute and also after 2 minutes. [. . . ] Clean the Magnetic door seal with a toothbrush and warm soapy water. Inspect the following when completed with cleaning: Is there any damage on the power cord or plug?(When in doubt, contact your dealer of purchase. ) Clean once a month Removing accompanying parts (36 37 page) Shelves, pockets and cases within compartments Refrigerator body (interior and exterior) Easily dirtied parts Top of refrigerator Wash the top filter and filter cover with water and allow to dry in the shade. Thoroughly wipe off dirt from the filter mounting section. Discharge port Top filter Filter cover Door packing Thoroughly clean sides where the right and left doors meet. Filter mounting section Drip plate indentation ( section) Thoroughly wipe off accumulated dirt. Remove dust from the discharge port using a vacuum cleaner. (The light sensor may not work if dirty with oil film, etc. ) Light sensor Dry wipe the LCD panel. Wipe after performing key lock. (60 page) Data may change when touching the screen. AM 38 Notes Do not use polishing powder, benzine, hot water etc. If undiluted detergent is used or soapy water is not wiped off thoroughly, cracking of plastic parts can result. In this case, clean the tray with kitchen detergent (cream-type cleanser, etc. ) as quickly as possible. The tray may become scratched. Wipe any food oils adhered to plastic components When using chemical rags, be sure to follow the accompanied directions. as they can cause cracking of the plastic surface. Clean once a year Evaporating pan / Evaporating pan cover Water will be difficult to evaporate when dirty. Removing Hold both sides of the evaporating pan cover and angling upward. Pull the evaporating pan out. Evaporating pan Push into main unit holes Mounting Put the evaporating pan on the radiator plate, and then slide it in completely. Fit the pawls of the evaporating pan cover into the holes of the cabinet, and then push the cover to attach. Hold level to avoid spilling Evaporating pan cover Pull diagonally upward Handle to the front Tab (right / left) Water leakage and abnormal noise may occur when evaporation pan and cover are not properly mounted. Back of refrigerator, floor and walls There may be build-up of dust from convection of air. (When all doors are closed) The buzzer sound can be temporarily stopped. (60 page) If key lock is already set to ON, set to OFF and back to ON again. * The buzzer will sound again after about 2 days. 41 ENGLISH Cleaning the Automatic Ice Maker / What to do / Troubleshooting What to do Troubleshooting Symptom Refrigerator does not cool or cool well Reason / Remedy Is the ambient temperature high?Move refrigerator away from the heat source and reinstall in a place away from direct sunlight and in a well-ventilated and cool location. Loud noise produced by the compressor when operation starts · · Sound becomes quieter after a while. Loud noise produced once a day by the compressor · · Operating sound produced immediately after automatic defrost operation. Cracking or crunching sound · · Sound produced by expansion and contraction of inner walls and internal parts during cooling. The sound of ice dropping will be louder. Reference page There is noticeable noise There is fogging or condensation There is fogging or condensation within the compartments or condensation on the cooling panel There is condensation on the vegetable cases Right and left doors are not aligned Are succulent foods stored without wrapping?This is due to the high humidity maintained within the vegetable compartment. In the case of the right illustration, raise the left adjustable foot. Lower the Lower the right and left adjustable feet adjustable feet and tilt the refrigerator to the back side. [. . . ] The screen will turn off in about 5 seconds and Vacation Mode will start. 56 () Auto Ice Maker (turning off) OFF, . Turn the setting to OFF when ice cubes are not needed. 1 . Ice cubes will not be released when the ice cube corner is full. 2 " ". Select the "Auto Ice Maker" mark. To remake ice cubes 1 3 "CHOOSE/START". . [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP SJ-W36/40J




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP SJ-W36/40J will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.