User manual SHARP QT-CD80H

[. . . ] Please keep your invoice or receipt, which is supplied at the time of purchase. QT-CD80H(SUK) TINSE0007SJZZ YT <P=001> SPECIAL NOTES q If the model name contains a parentheses, the letters in the parentheses indicate the colour of the product. q Recording and playback of any material may require consent, which SHARP is unable to give. Please refer particularly to the provisions of the Copyright Act 1956, the Dramatic and Musical Performers Protection Act 1958, the Performers Protection Acts 1963 and 1972 and to any subsequent statutory enactments and orders. q This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. [. . . ] q Do not expose the unit to moisture, to temperatures higher than 60°C (140°F) or to extreme low temperatures. q Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generates electrical noise. q Hold the AC power plug by the head when removing it from the AC socket, since pulling the lead can damage internal wires. q When cleaning the heads, pinch roller, etc, remove the AC power plug from the wall socket as the unit contains high voltages. q Use the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. q If the unit does not work properly whilst in use, set the FUNCTION switch to STAND-BY and then to ON again. q If an electrical storm is taking place near you, it is suggested that you disconnect the AC power lead from the AC socket for safety. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. s Battery use q Insert the batteries according to the direction indicated on the rear panel. q Remove the batteries if they are weak or if the unit will not be used for long periods of time. To stop playback q "Cd" will be displayed. q The total number of tracks will be displayed. STOP Note: q When "Cd" or track number is displayed, the power is connected. If you will not be using the CD player, set the FUNCTION switch to STAND-BY. Precautions: q Do not open the CD compartment whilst the disc is rotating. q If the disc is damaged, dirty, or loaded upside down, the total number of tracks will not appear. q Playing certain compact discs at a high volume may cause mistracking. q The temperature range for playing compact discs is recommended to be 5°C (41°F) - 35°C (95°F). q If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. s APSS (Auto Program Search System) To move to the beginning of the next track To listen to the track being played again During playback, CUE UP During playback, DOWN REVIEW q To skip a number of tracks at one time, press the UP or DOWN button repeatedly until the desired track number is shown. q To start playback from a desired track, press the UP or DOWN button whilst in the stop mode to select the track number, and then press the PLAY/REPEAT button. s Cue and review During playback, To fast forward audibly CUE UP hold During playback, s Repeat play During playback, To repeat all of the tracks on the disc Press PLAY / REPEAT To fast reverse audibly DOWN REVIEW hold To cancel repeat play Press again PLAY / REPEAT Notes: q If the end of the disc is reached whilst cueing, CD operation will be paused. Press the REVIEW button for fast reverse or press the STOP button to stop CD operation. q If the beginning of the track is reached whilst reviewing, the mode will automatically switch to normal playback at that point. 3 4 QT-CD80H(SUK) TINSE0007SJZZ <P=002> Radio operation s Manual tuning 1 Set the FUNCTION switch to TUNER. 2 Select the desired frequency band. (FM ST, FM or AM) FM STERO ST 3 Press the TUNING (X or button to tune into the desired station. TUNING DOWN UP W) FM MHz FUNCTION TAPE TUNER CD BAND ST FM MONO FM STAND-BY ON AM MHz KHz AM q To receive an FM stereo tra nsmission , pres s th e BAND button so that the "ST" indicator on the display lights up. [. . . ] 3 Press the RECORD button. 8 QT-CD80H(SUK) TINSE0007SJZZ <P=003> SPECIFICATIONS SHARP reserves the right to make design and specification changes for product improvement without prior notice. q General Power source: AC 230 - 240 V, 50 Hz DC 12 V ["D" size (UM/SUM-1, R20 or HP-2) battery × 8] DC 3 V [ "AA" size (UM/SUM-3, R6 or HP-7) battery x 2 for tuner memory] 11 W MPO (Max. ); 8. 4 W (4. 2 W + 4. 2 W) (AC operation) RMS; 4. 6 W (2. 3 W + 2. 3 W) (DC operation, 10 % T. H. D. ) 10 cm (4") full-range speaker x 2 Headphones; 16-50 ohms (recommended; 32 ohms) Width; 480 mm (18-15/16") Height; 153 mm (6-1/16") Depth; 254 mm (10") 3. 2 kg (7. 1 lbs. ) without batteries FM; 87. 5 - 108 MHz AM; 522 - 1, 620 kHz q Tape recorder Frequency response: Signal/noise ratio: Wow and flutter: Motor: Bias system: Erase system: 50 - 14, 000 Hz (Normal tape) 50 dB 0. 25 % (WRMS) DC 12 V electric governor AC bias Magnet erase Power consumption: Output power: q Compact disc player Type: Signal readout: Audio channels: Quantization: Filter: D/A converter: Wow and flutter: Compact disc Non-contact, 3-beam semiconductor laser pickup 2 16-bit linear quantization 4-times oversampling digital filter 1-bit D/A converter Unmeasurable (less than 0. 001% W. peak) Speakers: Output terminal: Dimensions: Weight: q Radio Frequency range: TERMS OF GUARANTEE Sharp Electronics (UK) Ltd. ("Sharp") guarantees to provide for the repair, or at its option the replacement, of this product subject to the conditions listed below:- 1. [. . . ]