User manual SHARP MX-2010U/2310U OPERATION MANUAL

[. . . ] Never disconnect peripherals from the POS terminal while the POS terminal remains plugged into the AC outlet. This POS terminal has a built-in memory protection circuit, which is operated by rechargeable batteries. It is important to understand that all batteries will, in time, dissipate their charge even if not used. Therefore, to insure an adequate charge in the protection circuit, and to prevent any possible loss of memory upon installation, it is recommended that each unit be allowed to be recharged for a period of 24 to 48 hours prior to use by the customer. [. . . ] Due to the various opportunities of the software for individual customization your authorized SHARP dealer may have programmed your POS Terminal differently as described in this manual. Please ask your SHARP dealer to explain these specially programmed settings and their operations. Screen Example (REG mode) Information area2 Scroll guidance/Cursor up key Main display area Information area1 Numeric key data area Total and REG status display area/Cursor down key Time area Common status area When you turn the POS terminal on and press the m key, the mode selection window will appear on the display, listing available operating modes as shown below. Mode selection window OPXZ Mode: Allows cashiers/clerks to take X or Z reports for their sales information. SD CARD Mode: Provides data communications between the POS terminal and your personal computer using a SD card. Department entries (direct department entries) Enter a unit price and press a department key. Department entries (indirect department entries) Enter a unit price and press the ` key. If you use a programmed unit price, you don't need to press the ` key. PLU entries (direct PLU entries) Press a direct PLU key when you use a programmed unit price. procedure When using a programmed unit price Unit price (for subdept. You can use this function for entering a sale of two or more the same items. Through (), item refund, or tip, you can void this entry by pressing the ~ key immediately. Before pressing the c key), you can void the entry by the cursor operation or the key sequence operation. Indirect void by cursor/touching operation You can void department, PLU/subdepartment, EAN, item refund, amount discount/premium and percent entries. Move the cursor to the item to be voided or touch it on the screen, then press the ~ key. procedure * Select the entry to be voided with or or touch it on the screen. Indirect void by key sequence operation You can void department, PLU/subdepartment, EAN and item refund. Press the ~ key just before you press a department key, à key, direct PLU key or s key or just before you scan an EAN code. For the refund indirect void, press the ~ key after you press the F key. à, direct PLU key, s à, direct PLU key, s 9) (Only for new guest entries) In case guest no. In case the copy receipt function is enabled, these operations can be repeated only once. GLU opening by GLU code Enter a GLU code and press the © key to open a new check. [. . . ] With this function, you can select some items from a guest check and make an entry for the payment. Also, you can transfer the items you have selected to other guest checks. there are three types of bill separating functions: bill separating by item , amount and person. To select another item To enter total q'ty * * You can also select the item by moving the cursor. [. . . ]