User manual SHARP LC-19LE510E

[. . . ] The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 5A fuse. Should or and of the same rating the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked as above, which is also indicated on the pin face of the plug, must be used. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type. DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner. [. . . ] If you select AERIAL option from the Search Type screen, the television will search for digital terrestrial TV broadcasts. Whenever you select an automatic search type and press OK button, a confirmation screen will appear on the screen. After auto channel scan type is set and selected and confirmed, installation process will start and progress bar will move along. After all the available stations are stored, Channel List will be displayed on the screen. If you like the sort channels, according to the LCN, please select "Yes" and than press "OK". ⷠSelect Manual Channel Scan from the Installation menu by using " "/" " and OK buttons. Use " "/" " button to highlight an item and then press " " or " " button to set an option. You can select options by using " "/" " and OK buttons. In manual channel scan, the number of the multiplex or frequency are entered manually and only that multiplex or frequency are searched for the channels. After selecting search type as Digital Aerial, you can enter the multiplex or frequency number using the numeric buttons and press OK button to search. In cable manual scan, you can enter frequency, modulation, symbol rate and network channel scan options. After selecting search type as Digital Cable, you can set the desired options and press OK button to search. If you start Digital Cable scan process, the following screen will be displayed. After selecting search type as analogue, you can use " "/" " button to highlight an item and then press " " or " " button to set an option. When the channel is located, any new channels that are not on the list will be stored. For highlighting lines you see, use " " or " " button. You can enter the frequency range manually by using the numeric buttons on the remote control. set Start and Stop Frequency as desired by using numeric buttons on the remote control. After this operation, you can set Search Step as 8000 KHz or 1000 KHz. If you select 1000 KHz, the Tv will perform search process in a detailed way. Note: If you select an extended gap between Start and Stop frequency rate, automatic search duration will take a longer time. Select Analogue Fine Tune from the Installation menu by using " " or " " and OK buttons. [. . . ] The problem may be an inconsistency with standards from the source equipment (DVD, Set-top box, etc. If you do experience such a problem please contact your dealer and also the manufacturer of the source equipment. When connecting devices to your TV's connectors by using DVI converter cables (not supplied), you can refer to the following resolution information. Note: It is not guaranteed that all DivX® formats are supported. [. . . ]