User manual SHARP KC-850U

[. . . ] KC-850U AIR PURIFIER with Humidifying Function OPERATION MANUAL Purificateur d’air à fonction d’humidification MANUEL D’UTILISATION PURIFICADOR DE AIRE Con función de humidificación MANUAL DE OPERACIÓN Device of this mark is a trademark of Sharp Corporation. “Plasmacluster” and “Device of a cluster of grapes” are registered trademarks of Sharp Corporation in Japan , USA and elsewhere. This product earned the ENERGY STAR by meeting strict energy efficiency guidelines set by the US EPA. US EPA does not endorse any manufacturer claims of healthier indoor air from the use of this product. [. . . ] 4 •Replace the Water Tank in thewhen the Water The top latch will “click” in place Tank is properly installed. € Do not use hot water (104ºF or 40ºC), chemical agents, aromatic substances, dirty water, or other damaging substances, deformation and/or malfunction may occur. Use of other water sources may promote the growth of mold, fungus and/or bacteria. 14 10:35:08 AM ENGLISH 1 Remove the Water Tank by unlatching the top. OPERATION Fan Speed Quick Clean MODE Button Plasmacluster Button ON/OFF Button Clean Air MODE Button Clean Air & Humidify MODE Button Power OFF Button CLEAN AIR & HUMIDIFY MODE Use the Clean Air & Humidify Mode to quickly clean the air, reduce odors and to humidify. € If the power cord was not unplugged between uses, the unit will automatically re-start at the previously selected settings. (See E-13) About Automatic Humidify Mode The Temperature/Humidity sensors automatically detect and adjust humidity according to changes in room temperature. Depending on the size and humidity of the room, humidity may not reach 45 - 55 %. in such cases , it is recommended that CLEAN AIR & HUMIDIFY/MAX MODE be used. Temperature 64 and below 64-75 75 and above Humidity 55% 50% 45% CLEAN AIR MODE Use the Clean Air Mode when additional humidity is not required. € If the power cord was not unplugged between uses, the unit will automatically re-start at the previously selected settings. By continuously discharging strong airflow cycles, the unit effectively removes airborne dust, pollen, mold and allergens from the air as they are drawn through the filter system. The unit humidifies when there’s water in the Water Tank, and it operates without humidifying when there is no water in it. Button on the display to select this When the operation finishes, the unit will return to the prior operation. Please note the fan speed cannot be adjusted during the QUICK CLEAN Mode. AUTO operation The fan speed is automatically switched (HIGH*, MEDIUM, LOW) depending on the amount of impurities in the air. POLLEN mode operation MAX operation MEDIUM operation LOW operation The unit will operate at High level for 0 minutes, then will alternated between MED and HIGH every 20 minutes. FAN SPEED Button * HIGH fan speed is an intermediate speed between MEDIUM and MAX. Plasmacluster ON/OFF Button Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion Mode ON and OFF. When Plasmacluster is ON, both the Indicator Light and Plasmacluster Indicator Light on the front display turn on. Indd 13 OPERATION LIGHTS CONTROL Button Use when the light on the front panel is too bright. Refer to the diagram to select the desired brightness on the front panel. [. . . ] Use the date labels as a reminder for when the filters should be replaced. Disposal of Filters Please dispose of used filters according to any local laws and regulations. 14 10:35:12 AM ENGLISH True HEPA filter Up to 5 years after opening TROUBLESHOOTING Before calling for service, please review the Troubleshooting chart below, since the problem may not be a unit malfunction. The Front Monitor illuminates orange or red even when the air is clean. [. . . ]