User manual SHARP HT-CN400DVH

[. . . ] To prevent accidental short circuits between and terminals, connect the speaker wires to the speakers first and then to the unit. HT-CN400DVE HT-CN500DVE HOME CINEMA WITH DVD If you require any advice or assistance regarding your Sharp product, please visit our web-site www. sharp. co. uk/customersupport. [. . . ] Customers without Internet access may telephone 08705 274277 during office hours (or (01) 676 0648 0101 if telephoning from Ireland). Connect the wires to the speakers. Connect the other end to the main unit. Red Red Supplied aerial connection Connections to TV Setting VIDEO OUTPUT When connecting to the SCART OUT socket or S-VIDEO socket, switch the VIDEO OUTPUT setting accordingly. See page 23 in the operation manual. Black Red FM aerial AM loop aerial Caution: Do not connect a TV or VCR to SCART OUT, S-VIDEO OUT and VIDEO OUT at the same time. To video input socket TV Black Black Black Red Video cable (commercially available) Video signal To S-video input socket S-video cable (commercially available) Video signal SCART cable (supplied) To SCART input socket Caution: Do not short-circuit the speaker wires. If playback does not start, press the PLAY button. Go to the step 5 If trouble occurs Battery installation Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). Do not mistake and . When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. ) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1 Set the unit to the stand-by mode and turn the power on again. 2 If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. Back of remote control When the protection circuit is activated: When short-circuiting the speaker leads or turning the volume too high, the protection circuit may be activated and the system may enter the stand-by mode. [. . . ] Do not mistake and . When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. ) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1 Set the unit to the stand-by mode and turn the power on again. [. . . ]