User manual SHARP FO-DC500

[. . . ] WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] €¢ If the machine was unable to establish communication with the LDAP server, an error message will appear. Follow the instructions in the message (you may need to check the LDAP settings in the machine’s Web page or consult your network administrator). Book Page 120 Thursday, May 13, 2004 8:51 AM Using an LDAP Server: Searching for Destinations and User Authorization Storing your login name in a personal book To store your login name when using the operation panel of the machine to create a personal book, see the procedure on page 54. To store your login name when using the machine’s Web page to create a personal book, enter your login name in Login Name (Optional) in the Personal Address Book Setup page (to open this page, click Personal Address Book under Setup in the Web page menu, and then click Add in the page that appears). To check or edit the entries in a previously created personal book, click Personal Address Book under Setup in the Web page menu, select the name of the book in the Book Name List, and then click Edit. To check or edit a previously created personal book from the operation panel of the machine, follow the procedure on page 54 and enter the number of the book in Step 5. Network Printer Option The FO-NP1 Printer Expansion Kit allows the FO-DC500/525/600 Document Communication System to be used as a network printer. The features of the printer include: ♦ Print speeds of up to 16 pages per minute. Your dealer must install the FO-LN1 network interface kit and the FO-NP1 network scanner kit. The IP address of the machine must be set as explained in the following section. The printer driver must be installed in all computers on the network that will be using the printer. The printer driver is installed from the CD-ROM that is included in the network printer kit. The procedures for installing the printer driver and configuring print settings are explained in this chapter. Setting the IP address of the machine To allow computers to communicate with the printer over the network, the printer must be assigned an IP address. This procedure should be performed by the network administrator or administrator of the machine, and is explained in Setting the IP Address on page 76. Note: Although “DHCP” is available as a setting for the IP address (this means that the machine automatically obtains an address from a DHCP server), it is recommended that a permanent IP address be assigned to the machine. If DHCP must be used, it is recommended that the DHCP lease time for the IP address be set to unlimited. ™¦ Note that the printer cannot be directly connected to a computer using a parallel cable. The printer must be connected to the network through the FO-LN1 network interface kit. ™¦ If you plan on moving the printer, contact your Sharp dealer. Book Page 122 Thursday, May 13, 2004 8:51 AM Installing the Printer Driver Installing the Printer Driver The SHARP PCL XL printer driver printer driver is provided in the CD-ROM in the FO-NP1 printer kit. This driver must be installed in every computer that uses the printer. [. . . ] Regulatory Information US Information Information on the label: Not required TSCA(Toxic Substances Control Act): All chemical substances in this product comply with all applicable rules or order under TSCA. sARA(Superfund Amendments and Reauthorization Act) Title III 302 Extreme Hazardous Substance: None 311/312 Hazard Categories: None 313 Reportable Ingredients: None California Proposition 65: This product contains no chemical substances subject to California Proposition 65. EU Information Information on the label (88/379/EEC) and 67/548/EEC) : Symbol & Indication : Not required R-phrase : Not required S-phrase : Not required 76/769/EEC: All chemical substances in this product comply with all applicable rules or order under 76/769/EEC. Other Information NFPA Hazard Rating: The National Fire Protection Agency(USA): Health: 1 Flammability: 1 Reactivity: 0 HMIS Rating: The National Paint and Coating Association(USA): Health: 1 Flammability: 1 Reactivity: 0 Recommended Uses: Toner for Electrophotographic Equipment Restrictions: This information relates only to the specific material designated as supplied by the manufacturer. [. . . ]