User manual SHARP FO-4470

[. . . ] WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Print out the Confidential Reception List as explained on page 116 to see which mailbox has received the document, and then follow the steps below to print out the document. 73 Polling Polling Polling allows you to call another fax machine and have it send a document to your machine without operator assistance. In other words, the receiving fax machine, not the transmitting fax machine, initiates the transmission. ™ If desired, you can dial more than one fax number to receive documents consecutively from a group of fax machines (this is called "Serial Polling"; a maximum of 154 fax machines can be polled in one operation). MODE ENTER STATION # 2 Dial the number(s) of the fax machine(s) you want to poll using one (or more) of the following methods: • Press one or more Rapid Keys. (If you enter less than 2 digits, press SPEED DIAL before each START/ ENTER to complete the entry. € Enter one or more full fax numbers with the numeric keys, pressing after each full number. Note: If you need to delete a number, press appears in the display and then press STOP START/ ENTER or until the destination . Polling Serial Polling using a Group Key If the fax machines you want to poll have all been programmed into one Group Key, you can poll them by simply pressing that Group Key. ) ♦ Make sure no documents are in the feeder before you press the Group Key. Being polled (Memory polling) To let another fax machine poll your fax machine, you must first store the document(s) in memory using the following procedure. Transmission will take place when the other fax machine calls your fax machine and activates polling. You can choose whether to allow polling only once, or an unlimited number of times. In the latter case, your fax machine can be used as an electronic "bulletin board". To add a document to others already stored, simply repeating the storing procedure (note that if Department Control is activated, documents cannot be added by a department other than that which stored the first document). When polling is initiated, the polling machine will receive all documents stored. If you allow polling an unlimited number of times, the document will remain in memory until you clear it as explained in the following section, Clearing a document. Special Functions ♦ If you allow polling only once, the document(s) will be automatically cleared Polling 4 Press 1 to select SET. 1:MEMORY POLL SET 1=1 TIME, 2=REPEAT • If another document has already been stored, press 1 to select APPEND, and go to Step 6. 5 6 Press 1 to allow polling only once, or 2 to allow polling an unlimited number of times. RESOLUTION CONTRAST Press and/or to adjust the resolution and contrast if desired, and then press START/ ENTER . € The document will be scanned into memory, and your fax will go on polling standby. [. . . ] Precautions: Do not throw the toner cartridge or toner into a n open flame. Regulatory Information US Information Information on the label: Not required TSCA(Toxic Substances Control Act): All chemical substances in this product comply with all applicable rules or order under TSCA. sARA(Superfund Amendments and Reauthorization Act) Title III 302 Extreme Hazardous Substance: None 311/312 Hazard Categories: None 313 Reportable Ingredients: None California Proposition 65: This product contains no chemical substances subject to California Proposition 65. EU Information Information on the label (88/379/EEC) and 67/548/EEC) : Symbol & Indication : Not required R-phrase : Not required S-phrase : Not required 76/769/EEC: All chemical substances in this product comply with all applicable rules or order under 76/769/EEC. [. . . ]