User manual SHARP CV-2P10SC

[. . . ] PORTABLE TYPE ROOM AIR CONDITIONER INSTALLATION AND OPERATION MANUAL ACONDICIONADOR DE AIRE PARA HABITACIÓN TIPO PORTÁTIL MANUAL DE INSTALACIÓN Y FUNCIONAMIENTO ENGLISH ESPAÑOL CV-2P10SC This product can also be used as an ion generator Device of this mark is a trademark of Sharp Corporation. plasmacluster is a registered trademark or a trademark of Sharp Corporation. 22 11:00:11 AM FOR CUSTOMER ASSISTANCE (the United States) To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the back side of the unit. MODEL NUMBER SERIAL NUMBER DATE OF PURCHASE Dealer Name Address City State Zip Telephone TO PHONE: Dial 1-800-BE-SHARP (237-4277) for: SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION TO WRITE: For service problems, warranty information, missing items and other assistance: Sharp Electronics Corporation Customer Assistance Center 1300 Naperville Drive Romeoville, IL 60446-1091 TO ACCESS THE INTERNET: www. [. . . ] 3" (540mm) high, as you will be unable to shut the exhaust cover. (2) Open the window sash and place the window panel on the window frame. Adjustment panel ENGLISH (1) Open the window sash and place the window panel on the window frame. 9" (1800mm) Use the window panel, the adjustment panel and the extension panel. (1) Open the window sash and place the window panel on the window frame. (2) Slide the adjustment and extension panels to fit the window frame height. 9" foam seal B proper 5 Cut theand attach themto the window length to the panel. Securely against the Foam seal B (adhesive type) 7 Attach the bracket with a screw. (Recommended) Please lay a tabular material underneath the window panel in case you could not attach the rain guard or the window adapter properly due to the deep window sill. 22 11:00:14 AM INSTALLATION AND REMOVAL OF EXHAUST HOSE Installation of the exhaust hose 1 Attach the window adapter to the exhaust hose. Extend one end of the exhaust hose and insert it into the window adapter, and turn it (approx. Window adapter Extend Exhaust hose 2 Attach the exhaust hose to the unit. Exhaust hose Insert the two projections into the two holes on the unit, and firmly attach them to each other until they click. Panel, and attach the winthe window dow (Double-hung sash window) Surface of window adapter marked "TOP" should be at the top. (Sliding sash window) Surface of window adapter marked "TOP" should be on the window frame side. Exhaust cover "TOP" The exhaust hose should be as short as possible for operational efficiency; however, it must not be twisted or bent. 22 11:00:15 AM Removal of the exhaust hose 1 Remove the window adapter. Pull out and remove the window adapter by pushing down two “PUSH” markings, and slide and close the exhaust cover in the window panel. "PUSH" ENGLISH 2 Remove the exhaust hose from the unit. Lift up and remove the exhaust hose from the unit by pushing on the two projections. 22 11:00:15 AM PRE-OPERATION CHECKS POWER PLUG CHECK This unit uses a fused power plug. The circuit breaker is activated, power is supplied, and the unit is now ready for use. [. . . ] bEFORE NON-USE FOR A LONG PERIOD out water 1 Perform drainage to draindrainpipe. Within the unit and replace the stopcock securely to the the FAN 2 Operate the unit ininside theor VENTILATION mode for about half a day to thoroughly dry unit. 22 11:00:19 AM BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, check the following points before calling for a service. UNIT DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose? [. . . ]