User manual SHARP CD-M10000W

[. . . ] To obtain the best performance from this product, please read this manual carefully. Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble the cabinet. When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still present inside the unit. [. . . ] " Playback will begin from track 1 on the disc you have selected to play. After that disc finishes playing, the next disc will automatically start playback. " When the last track on the third disc has finished playing, the CD player will stop automatically. " When there is no CD in one of the disc 1 - 3 positions, that position will be skipped and the next CD will be played. " The or button on the remote control allows you to locate the beginning of a track. " " " " " Do not place two CDs in one disc tray. If the power fails whilst the tray is open, wait until the power is restored. If the disc tray is stopped forcibly, "ER-CD10" will appear in the display and the unit will not function. If this occurs, press the ON/STAND-BY button to enter the power stand-by mode and then turn the power on again. " If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. " If a disc is damaged, dirty, or loaded upside down, the disc will be skipped. " When the end of the last track is reached during fast forward, "END" will appear on the display and CD operation will be paused. When the beginning of the first track is reached during fast reverse, the unit will enter the playback mode. Starting playback with a desired track You can play a disc starting with the desired track. The tracks on the disc(s) can be played in random order automatically. Selected track number You can also select a track by pressing the trol. When the end of last track of the disc selected is reached, the next disc will be automatically started. Within 30 seconds, press the MEMORY/SET button to store that station in memory. " The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each. To erase entire preset memory If the "MEMORY" and preset number indicators go out before the station is memorised, repeat the operation from step 2. Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorised will be erased. [. . . ] When using video equipment, connect the audio output to this unit and the video output to a television. Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre. " If a power failure occurs during playback, the heads remain engaged with the tape. [. . . ]