User manual SHARP AY-XPC12JHR

[. . . ] It means that used electrical and electronic products should not be mixed with general household waste. In the European Union Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. [. . . ] The filters are sealed in a plastic bag to keep their dust collection effect. If the AUX button is pressed during normal operation, the unit will turn off. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. When using your air-conditioner with multi-system With a multi system air conditioner, multiple indoor units can be connected to one outdoor unit. When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work. ⷠWhen the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in COOL or DRY mode. ⷠWhen the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not operate in HEAT mode. When the mode of the indoor unit(s) later operated is/are different from those which is/are in operation, after a few seconds, a long BEEP will be emitted and the temperature indicator " and on the indicator panel will indicate" the OPERATION lamp and TIMER lamp will blink alternately. In such case, change the mode to the same mode which the other indoor unit(s) is/are operating in. The indicator panel will change each time you press the DISPLAY button in the following manner. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. ⷠDuring operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. The displayed temperatures are rough estimates and may vary from the actual temperatures. ⷠTemperature display ranges Room temperature: 0°C ~ 40°C ( is displayed when less than 0°C and when higher than 40° C) Outdoor temperature: ­9°C ~ 45°C ( is displayed when less than ­9°C and when higher than 45°C) · Is displayed during the first about 0~120 seconds of operation while the temperatures are being detected. Room and outdoor temperature will not be displayed even if you press the DISPLAY button. When using your air-conditioner with multisystem, mode of the unit operated first will have priority over other unit(s) without reference to the above chart. Only the room temperature can be displayed for 5 seconds when the unit is not in operation. Manual adjustment of the open panel and the louvres can cause the unit to malfunction. The open panel will be set obliquely downward for 10 minutes, and then shift to obliquely upward to deliver cool air to the ceiling. The open panel will be set obliquely backward when outlet air temperature is low, and then shift to obliquely downward when outlet air becomes warm. When the room becomes warm, it will be set downward to deliver the warm air to the floor. [. . . ] When one indoor unit is operating in HEAT mode, you can not operate the other unit in COOL nor DRY mode. (After a few seconds , a long BEEP will be emitted , and the temperature indicator on the indicator panel will indicate" " and the OPERATION lamp and TIMER lamp will blink alternately. ) UNIT DOES NOT SEND OUT AIR (PLASMACLUSTER operation without accompanying air conditioning mode, SELF CLEAN operation) The other unit(s) is/are de-icing. If the unit appears to be malfunctioning, check the following points before calling for service. [. . . ]