User manual SHARP AR-M150 CAUTIONS

[. . . ] Should the fuse need to be replaced, a BSI or ASTA approved fuse to BS1362 marked or and of the same rating as the one removed from the plug must be used. Always refit the fuse cover after replacing the fuse on the moulded plug. [. . . ] *4 The machine does not support printing from a Macintosh environment. *5 Administrator's rights are required to install the software using the installer. Before using your machine and before installing the software, please read carefully the user manual included in the CD-Rom. Double-click the "Manual" folder, double-click on your selected folder, and then double-click the "PDF" file. note If Acrobat Reader is not installed on your computer, · Double-click the "Manual" folder, double-click on your selected folder, and then double-click the "PDF" file. note If Acrobat Reader is not installed on your computer, · A paper form operation manual can be obtained from your authorized SHARP dealer. The label ( ) in the fusing area of the machine indicates the following: : Caution, risk of danger : Caution, hot surface Exercise care in this area when removing misfed paper. After turning the machine off, wait 10 to 15 seconds before turning it back on. When the machine is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet. When moving the machine, be sure to turn the power switch off and remove the power cord from the outlet. Do not cover the machine with a dust cover, cloth or plastic film while the power is on. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] To ensure continued safety do not remove any cover or attempt to gain access to the inside of the product. Dubbelklik op de map "Manual", dubbelklik op de door u geselecteerde map en dubbelklik vervolgens op het "PDF"-bestand. [. . . ]