User manual SHARP AR-120E/150E

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "0" on the copier instead of "ON" and "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. 1 2 3 4 5 6 7 8 Original cover Side cover Manual bypass Paper guides Side cover open button Front cover Papier tray Operation panel 9 Original table 10 Cover for optional printer interface 11 Paper output tray 12 Paper output tray extension 13 Handle 14 Power switch 15 Power cord socket 16 TD cartridge lock release button 17 TD cartridge 18 Drum cartridge 19 Drum cartridge handle 20 Transfer charger 21 Charger cleaner 22 Fusing unit release tab 23 Paper feed roller 3-8) 2 Light ({) and dark (}) keys and exposure indicators Use to adjust the MANUAL (=) or PHOTO ( ) exposure level. [. . . ] Press the light ({) or dark (}) key to lighten or darken the automatic exposure level as desired. If exposure level 2 is selected, the two left-handmost indicators for that level will light up simultaneously. Also, if level 4 is selected, the two righthandmost indicators for that level will light up simultaneously. This automatic exposure level will remain in effect until you change it again by this procedure. Three preset reduction ratios and two enlargement ratios can be selected. The zoom function enables copy ratio selection from 50% to 200% in 1% increments. Use the copy ratio selector key and/or zoom (N, L) keys to select the desired copy ratio. ⷠTo verify a zoom setting without changing the zoom ratio, press and hold down the copy ratio display (%) key. When the key is released, the display will return to the copy quantity display. ⷠTo reset the ratio to 100%, press the copy ratio selector key repeatedly until the 100% indicator lights up. When a zoom (N or L) key is pressed, the ZOOM indicator will light up and the zoom ratio will be displayed in the display. In order to quickly change the zoom ratio, press and hold down the (N or L) key. the displayed setting will stop on any preset reduction or enlargement setting. To further reduce or raise the zoom ratio, firstly release the key and then press and hold down. Set the number of copies using the copy quantity (<, <) keys and press the print ( ) key. The single-sheet manual bypass can be used to feed standard paper, transparency film, labels and other special purpose papers measuring from A6 to A4 and in the weight range of 52 to 130 g/m². (For paper weighing from 104 to 130 g/m², A4 is the maximum size. The original image must be smaller than the paper or media for copying. If the original image is bigger than the paper or media, this may cause smudging on the edges of the copies. Insert a single sheet of copy paper (print face down) into the feed slot of the manual bypass. ⷠWhen copying onto transparency film, remove each copy promptly. Example: The following two originals will be copied onto two sides of copy paper. [. . . ] However, be sure to lower the lever by rotating it all the way to the location where it will not rotate. Gently remove the misfed paper from under the fusing unit as shown in the illustration. Do not touch the surface of the drum (green portion) of the drum cartridge when removing the misfed paper. Unfixed toner on the paper may stain the paper transport area, resulting in smudges on copies. [. . . ]