User manual SHARP AN-3DG10S

[. . . ] · Be careful not to trap your finger in the hinge section of the 3D Glasses. Using the 3D Glasses · Parents/guardians should monitor children's viewing habits to avoid their prolonged use without rest periods. The surrounding area appears dark, which may result in falling or other accidents that may cause injury. Caring for the 3D Glasses · Use only the cloth provided with the 3D Glasses to clean the lenses. [. . . ] This may result in injuries due to running into objects, tripping, and/or falling. · When using the 3D Glasses, take care not to accidentally strike the TV screen or other people. Viewing 3D images may cause you to misjudge the distance to the TV screen and accidentally strike the screen, resulting in possible injury. Supplied Accessories Make sure the following accessories are provided with the 3D Glasses. 3D Glasses (×1) 3D Glasses band * (×1) Nose pad * (Large ×1, small ×1) Glasses case (×1) Cleaning cloth (×1) Precision screwdriver (Phillips ×1, slotted ×1) Operation Manual * Use the 3D Glasses band and nose pad as needed. · The illustrations above are for explanation purposes and may vary slightly from the actual accessories. EN-3 Using the 3D Glasses Part Names 12 1 Power button · Press for at least 2 seconds to turn on and off the 3D Glasses. · When the 3D Glasses are turned on, pressing this button switches between 2D and 3D modes. The 3D Glasses turn off automatically after 3 minutes if no signal is received from the TV. 3D Glasses band mount The dedicated 3D Glasses band can be mounted here. 3 3 4 6 4 5 6 5 · Do not soil or apply stickers or other obstacles to the infrared receiver. Doing so may block signals from the TV and prevent the 3D Glasses from working correctly. · Interference from other infrared communications equipment may prevent you from viewing 3D images correctly. Attaching the Nose Pad Attach either of the supplied nose pads as needed (such as when the glasses do not fit properly). The glasses come with a large and small nose pad. Attaching the 3D Glasses Band Attach the supplied 3D Glasses band strap as needed (such as when the glasses do not fit properly). Insert the ends of the 3D Glasses into the 3D Glasses band until they are secure. · Pull the cord stopper on the strap to adjust the strap length. Attaching the nose pad Removing the nose pad 1 2 1 EN-4 Using the 3D Glasses Before Using the 3D Glasses Before using the 3D Glasses for the first time, remove the insulating sheet attached to them. Using the 3D Glasses Turning On/Off the Power Turn on the power of the 3D Glasses. · Press the power button for at least 2 seconds. · The LED light blinks 3 times. Turn off the power on the 3D Glasses. · Press the power button for at least 2 seconds. · The LED light lights for 2 seconds. Replacing the Battery The battery has an expected service life of approximately 75 hours. · When the battery power is low, the LED light blinks 6 times after the power is turned on. · When replacing the button battery, use only the designated battery (Maxell branded CR2032 lithium button battery). 3 Place the tip of the slotted precision screwdriver into the opening between the battery and the socket. 4 Lift up the battery while taking care not to get the screwdriver caught on the metal latch. 5 When the battery comes loose from the socket, pick it out with your fingers. 6 Hook a new battery to the metal latch and insert it into the socket. 8 Insert the screw to secure the battery cover. · When the battery power is low, the LED light blinks 6 times after the power is turned on. Switching to 3D and 2D Mode When viewing 3D images, you can press the power button to switch between 2D and 3D modes. This is useful when several people are viewing 3D images on the same TV with some people wanting to watch in 3D and some people wanting to watch in 2D. Viewing 2D images When you press the power button twice while viewing 3D images, the LED light blinks 2 times and the 3D images switch to 2D images. Viewing 3D images When you press the power button twice while viewing 2D images, the LED light blinks 3 times and the 2D images switch to 3D images. Usage Range of the 3D Glasses The 3D Glasses can be used by receiving an infrared signal sent from the TV. The 3D Glasses turn off automatically after 3 minutes if no signal is received from the TV. 1 2 3 4 5 6 8 7 · Take care not to reverse the battery poles (+ and ­) when loading the battery. · Used batteries should be disposed of strictly in accordance with the applicable local laws and regulations. EN-5 Using the 3D Glasses · These 3D Glasses are only for use with Sharp LCD TVs supporting 3D. 3D Glasses lenses · Do not apply pressure to the lenses of the 3D Glasses. [. . . ] Sharp does not warrant nor shall Sharp be liable, or in any way responsible, for Products which have been subject to abuse (including, but not limited to, improper voltage), accident, misuse, negligence, lack of reasonable care, alteration, modification, tampering, misuse, improper operation or maintenance or any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than a Sharp authorized servicer. Nor shall Sharp be liable or in any way responsible for any incidental or consequential economic or property damage. Some states do not allow limits on warranties or on remedies for breach in certain transactions; in such states, the limits herein may not apply. THIS LIMITED WARRANTY IS VALID ONLY IN THE FIFTY (50) UNITED STATES, THE DISTRICT OF COLUMBIA. Model Specific Section YYour Product Model Number & Description: AN-3DG10-S / AN-3DG10-R / AN-3DG10-A 3D Glasses (Be sure to have this information and Proof of Purchase available when you need service for your Product. ) One (1) year parts and labor from date of purchase. [. . . ]