User manual SHARP AF-Q60RX
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP AF-Q60RX. We hope that this SHARP AF-Q60RX user guide will be useful to you.
Manual abstract: user guide SHARP AF-Q60RX
Detailed instructions for use are in the User's Guide.
[. . . ] ES-9
NDICE -PORTUGUS-
PGINA
Este MANUAL DE INSTALAO E UTILIZAO explica como utilizar correctamente o seu novo ar condicionado da Sharp. Leia com ateno as instrues antes de instalar ou utilizar o seu ar condicionado. O MANUAL DE INSTALAO E UTILIZAO deve ser guardado num lugar seguro e de rpido acesso.
NOMES E DIMENSES DAS PEAS . P-8 ANTES DE CHAMAR O SERVIO DE ASSISTNCIA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The air conditioner should be installed with a strong external support to minimize noise and vibration, and for the purpose of safe installation, repair, replacement and secure positioning. Avoid installing the air conditioner where it is exposed to direct sunlight.
36. 0~37. 0 cm (14 3/16"~14 9/16")
More than 20 cm (8")
cm 49. 0 48. 0~ 6") 9 5/1 /8"~1 (18 7
More than 20 cm (8")
8~20 cm(3"~8")
More than 40 cm (16") Air outlet Air inlet
More than 20 cm (8")
More than 40 cm (16")
Air inlet
More than 20 cm (8")
Air inlet
Air outlet
About 1 cm (3/8")
Air inlet
GROUNDING
WARNING: THIS APPLIANCE MUST BE GROUNDED. This appliance is equipped with a cord having a grounding wire with a grounding tab. The plug must be plugged into an outlet that is properly installed and grounded.
Plug
Grounding tab
FUSE
For safe, trouble free operation, connect the power cord of the unit to a properly rated 10 amp independent circuit with a time delay fuse or a circuit breaker.
E-2
ENGLISH
INSTALLATION INSTRUCTIONS
INSTALLATION
WARNING: Turn off and disconnect the unit before working.
Grille
1
(1) Open the grille (Fig. 1) by gently pulling
the arrow marked portion. (Fig. 2) Keep the screw as it will be used later.
Hinge
, , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,
Air filter
, , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,
2 1
Front panel
Fig. 1
Fig. 2 Hinge support
CAUTION;
Do not provide stress to the opened grille. When the grille is opened extremely wide, the hinge joints may come off. In such case, push the hinge joint into the hinge support (upper and lower accordingly) and replace the grille.
Grill
Hinge joint
(2) Close the grille firmly, and remove the
front panel by pulling the front panel at the lower corners towards you for about 3 cm (1" ). (Fig. 3)
2
2
(1) Unscrew the 4 stopper screws (3 stopper
screws for model AF-A1288) of the cabinet (Fig. 4). Keep the front screw and the angle as they will be used later in step 6.
Front panel
Fig. 3
1
Cabinet
(2) Slide the chassis out from the cabinet
by pulling the hand hold located at the bottom center of the chassis. (Fig. 4)
Fig. 4 Angle Chassis
3
Attach the provided drain tray to the cabinet in case drainage becomes necessary. (Fig. 5)
Fig. 5 Drain tray Cabinet
E-3
INSTALLATION INSTRUCTIONS
When drainage is necessary
If water drainage is necessary in high humidity district, or if you do not like the splashing sound of the non-drain function, remove the rubber cap on the bottom of the chassis. A built-in protective device might prevent the unit from operating when used out of this range. Condensation might form on the air outlet when the unit operates continuously in the COOL mode when the humidity is over 80 percent.
NOISE LEVEL Noise from the air conditioner will be louder at night than in the daytime. This is because noise in the surroundings is comparatively low at night. If you feel that noise of the air conditioner is too loud, switch the "SELECTOR" knob to the "LOW COOL" position. WATER IN THE BOTTOM TRAY Water will be collected at the bottom tray of the unit. Water condenses on the evaporator coil in the front of the unit and is channeled to the rear where it is picked up by the condenser fan. The water is blown onto the condensor coil fins, this creates a "splashing" sound which is normal. When the tray is filled up with water, excessive water will be drained outside through a grooved channel in the tray.
E-5
MODES OF OPERATION
HOW TO OPERATE
5
2
1
1 Control panel 2 Auto swing switch 3 Thermostat knob
4 Selector knob 5 Ventilation lever
3
4
ENGLISH
SELECTOR KNOB Use to select the desired mode. Fan operates at medium speed; cooling power at medium.
OFF
LOW COOL MED COOL
FAN ONLY
This setting can be used to circulate air whenever cooling is not desirable. The fan will operate at medium speed.
Fan and cooling at maximum power. HIGH COOL
E-6
MODES OF OPERATION
THERMOSTAT KNOB Use to adjust the desired room temperature setting. [. . . ] Never use harsh chemicals or abrasive cleaners on any part of the unit. To avoid damaging the unit, do not use hot water of over 50C when cleaning.
OILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY
The compressor is permanently lubricated and is hermetically sealed. The fan motor is lifetime sealed and does not require oiling.
E-8
ENGLISH
BEFORE CALLING FOR SERVlCE
IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECK THE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE.
AIR CONDITIONER DOES NOT OPERATE AT ALL
Is the power cord loosened or unplugged?If the power was off for less than 3 minutes, and you restart the air conditioner within 3 minutes, a protective device may cause the air conditioner to shut off, preventing cooling operation for about 5 minutes.
AIR CONDITIONER DOES NOT COOL PROPERLY
Is the SELECTOR set to FAN ONLY ( )? [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP AF-Q60RX
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP AF-Q60RX will begin.