User manual SENNHEISER SET 830 S

[. . . ] Cordless TV Listening System Set 830 S Instruction manual I 1 7 2 34 7 5 6 Q II D C 8 9 B A 0 EF G H Contents Contents Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Delivery includes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Product overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Putting the Set 830 S into operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Connecting the induction loop Carefully remove the clip O from the receiver. If the transmitter doesn't switch on: Read the chapter "If a problem occurs . . . " on page 24. To disconnect the transmitter from the mains: Pull out the mains connector from the wall socket. Note: When not using the transmitter for extended periods of time (e. g. when you are on holiday), pull out the mains connector from the wall socket. In this case, however, the receiver's rechargeable battery will not be recharged. 14 Using the Set 830 S system Switching the receiver on/off CAUTION!This receiver allows you to set higher volumes than conventional headphones. This can cause hearing damage in persons with healthy hearing and especially in children. Before using the receiver, set the volume on the receiver to a low level. To switch the receiver on: Press the on/off button 3 until the channel indicator 1 lights up. The channel indicator 1 goes off after 30 seconds. 1 3 To switch the receiver off: Press the on/off button 3 until the channel indicator 1 goes off. ­ If you are not within the range of the transmitter, the receiver automatically switches off after 3 minutes. 3h 15 Using the Set 830 S system Adjusting the volume Use the volume control 2 to adjust the volume to a sufficient and comfortable level. Searching for a sound source Switch the receiver on. Yes: The receiver has already found the sound source. 15 No: Briefly press the channel search button 5. On the receiver, the channel indicator 1 can light up as follows: Channel indicator Frequency 2. 3+2. 8 MHz 2. , 3 MHz 2. 8 MHz You hear the sound in stereo mono If you have not yet found your sound source, press the channel search button once more. If you still cannot find your sound source: Read the chapter "If a problem occurs . . . " on page 24. Note: The channel indicator goes off after 30 seconds so that the light won't disturb you in a dark room. 16 Using the Set 830 S system Adjusting the balance 4 The balance control allows for right/left volume adjustment. Turn the balance control 4 to the left L or right R in order to increase the volume for the corresponding ear. Switching between mono and stereo operation If, despite a correct balance adjustment, you can hear the sound only with one ear: Set the ST/MO switch F of the transmitter to MO (mono). F Meaning of the terms "mono" and "stereo" Stereo (ST) Mono (MO) L R L+R Example: L: Speech from the left R: Music from the right You hear speech from the You hear speech and music left and music from the coming from the front. right. 17 Using the Set 830 S system Individually enhancing the speech intelligibility D C The "speech intelligibility" button C allows you to adjust the sound to your individual needs. Press the "speech intelligibility" button C sound is optimally adjusted to your needs. Press the button Indicator D is lit yellow Setting 1 2 3 Default setting 1x 2x 3x until the 4x If necessary, you can have the speech intelligibility fine adjusted to your hearing ability (see page 27). 18 Using the Set 830 S system Storing and charging the receiver After use, place the receiver into the transmitter's charging compartment 8 without exerting too much pressure. When the receiver is placed correctly into the charging compartment, the indicator A lights up: red: The battery is being charged. green: The battery is fully charged. B A Notes: ­ With a fully charged battery, the operating time is up to 12 hours. [. . . ] for power supply or rechargeable battery) may cause damage to the device and will invalidate the warranty!Use only original Sennheiser accessories and spare parts. For the Set 830 S, the following receivers and stethoset receivers are available from your specialist dealer: Cat. 502021 502020 502023 Accessory/spare part RI 830 S receiver RI 830 stethoset receiver RI 900 stethoset receiver 30 Accessories and spare parts The following Set 830 S accessories are available from your specialist dealer: Cat. 500898 502566 504061 003448 528185 528184 517627 500974 502710 Accessory/spare part BA 300 spare rechargeable battery EZT 3011 induction loop EZT 3012 induction loop EZI 120 induction couplers Lanyard Clip for attaching the receiver Extension cable, 3 m (3. 5 stereo jack plug) MKE 800 TV-N external microphone (mono) L 300 10-10 charger HZL connection cables HZL 30-6 (3. 5 mm jack plug to 1 mini-plug, 40 cm) HZL 30-600 (3. 5 mm jack plug to 1 mini-plug, 60 cm) HZL 32-6 (3. 5 mm jack plug to 2 mini-plugs, 40 cm) HZL 32-600 (3. 5 mm jack plug to 2 mini-plugs, 60 cm) HZL 34-6E (3. 5 mm jack plug to 1 Euro plug, 40 cm) HZL 34-600E (3. 5 mm jack plug to 1 Euro plug, 60 cm) HZL 36-6E (3. 5 mm jack plug to 2 Euro plugs, 40 cm) HZL 36-600E (3. 5 mm jack plug to 2 Euro plugs, 60 cm) 001676 004658 001678 004657 002408 004652 002409 004653 31 Specifications Specifications System Modulation Carrier frequencies Frequency response THD Charging time for rechargeable battery Signal-to-noise ratio (1 mV, peak deviation) Operating temperature Transmitter Range Audio/microphone connection Power supply Weight Dimensions Receiver Audio connection Power supply Operating time Weight Dimensions 3. 5 mm stereo jack socket via BA 300 rechargeable Li-Pol battery (3. 7 V / 150 mAh) up to 12 hours approx. [. . . ]