User manual SENNHEISER SET 810 S

[. . . ] Make sure the receiver is positioned correctly, with the operating control facing the transmitter. There must be a free line of sight between the transmitter and the receiver. 6 SET 810 S Using the induction neck loop Put the EZT 1011 induction neck loop around your neck and insert its plug into the socket at the top of the receiver. Set your hearing aid to position "T". English 7 Adjusting the volume Adjust the receiver's volume with the operating control. Make sure your hand doesn't cover the operating control completely. [. . . ] Varnish or furniture polish may degrade the rubber feet of the transmitter. Place the transmitter on a nonslip pad to avoid potential staining of furniture. According to today's scientific knowledge, the infrared light emitted by this unit is not harmful to humans or animals. SET 810 S 11 English WARNING: English Volume up?When people use headphones, they tend to choose a higher volume than with loudspeakers. However, if your hearing has deteriorated and you need to rely on an assitive listening system, please avoid listening at high volume levels for a long time. Neither transmitter nor receiver must get wet or excessively moist, e. g. due to spilled liquids or use in damp rooms. 12 SET 810 S Accessories Only use original Sennheiser spare parts and accessories. for power supply or battery) may cause damage to the unit and will invalidate the waranty. The following accessories are available from your authorized dealer: Rechargeable battery BA 151 Charger L 151-2 Additional receiver RI 810 S Transmitter TI 810 External microphone MKE 800 TV Induction couplers EZI 120 Dynamic headphones HD 25 SP HZL series connecting cable (for direct connection to hearing aids) SET 810 S 13 English English BA 151 rechargeable battery By using a spare battery, you can use the receiver for more than four hours of continuous operation. Always store the spare battery in the small charging compartment at the right of the transmitter. The right LED on the transmitter lights up green to show charging is taking place. When charging an battery in the small charging compartment, the charging time is 10-12 hours. L 151-2 charger Spare batteries can be charged via the L 151-2 charger. RI 810 S additional receiver One transmitter can transmit to several receivers. Additional RI 810 S receivers are available from your authorized dealer. 14 SET 810 S MKE 800 TV external microphone If your TV doesn't have a headphone output, SCART or RCA socket, you can use your Set 810 S together with the MKE 800 TV microphone. Fix the microphone to the loudspeaker of your TV by means of Velcro tape. Connect the microphone connector to the MIC socket on the transmitter and set the MO/ST switch to mono (MO). HD 25 SP dynamic headphones Closed dynamic headphones for connection to the RI 810 S. Any dynamic headphones with a 3. 5 mm stereo jack plug and a minimum impedance of 32 ohms can be connected to the RI 810 S receiver. EZI 120 induction couplers Induction couplers for inductive audio transmission to hearing aids. SET 810 S 15 English If problems occur. . . [. . . ] 35 g (without battery) length: 95 mm, width: 63 mm, height: 35 mm max. 10 kHz 47 100 mA/m at 1 kHz and 10 mVA 2 years 20 SET 810 S Manufacturer declarations CE Declaration of Conformity This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2006/95/EC. Before putting the device into operation, please observe the respective country-specific regulations! WEEE Declaration Your Sennheiser product was developed and manufactured with highquality materials and components which can be recycled and/or reused. This symbol indicates that electrical and electronic equipment must be disposed of separately from normal waste at the end of its operational lifetime. [. . . ]