User manual SENNHEISER MKE 80 R

[. . . ] "Complete" means that the microphone is a ready far use unlt which is specially intended to work with at often changing recarding places. The guaranteed data of the MKE 80 R show that it is a high qualified microphone which meets the high demands to sound quality of professional users. [. . . ] the condltion of the battery IS checked every time the microphone is sWltched on (red mark visible) ar off. When switching on, a LED (2) lights up, Indicatlng sufficient supply voltage (fig. When the microphone is not in use it should be switched off to prevent the battery from belng unnecessarily drained. For operation with voltages 01 less than 48 V, the supply voltage resistors in the supply device must lirst be changed over to the values listes in the table below. It primanly picks up sound sources which are directly In Iront 01the microphone (Iig. 4), Therelore, the mlcrophone should be directed in direction to the sound source. Should the microphone malnly be used with battery supply and seldom with phantom powering, the battery can remain in the handgrip/powering module during phantom powering. For reducing interferences caused by (Ior example) lootlall, wind or handling noise the handgrip/powering module leatures a 3-positlon switchable roll off lilter. Position II brings about a roll off 01 7 dB and position 1'1 reduction 0120 dB at 50 Hz (Iig. A In position I the lilter IS sWltched off, thus ensunng a Ilat Irequency response, However, the roll off lilter reduces not only Interfering noise, but also causes a reduction 01 part 01 the otherwise useable low Irequency range, Therelore, the roll off Illter should be used only I1interfenng noises cannot be ellminated by other means, For outdoor recording and close miking the use 01the wlndscreen MZW 415 IS recommended In order to effectively suppress avoldable interference without activating the roll off lilter. [. . . ] 1956) Shock mount with %" internal thread, lits to all tripods, desk stands and booms with %" thread. 2157) Cable lar connection 01 microphones wlth 3-pln XLR-3 plug, system Cannon, to balanced rnicrophone inputs with 3-pin screwable socket according to DiN 41 524. [. . . ]