User manual SENNHEISER HDI 1029-PLL16

[. . . ] 12 1 Safety instructions Safety instructions · Read this instruction manual carefully and in full before using the device. · Make this instruction manual easily accessible to all users at all times. Always include this instruction manual when passing the device on to third parties. · Do not use the device in situations which require special attention (e. g. [. . . ] · Use the device with care and store it in a clean, dust-free environment. · This receiver allows you to set higher volumes than conventional headphones. This can cause hearing damage in persons with healthy hearing and especially in children. Proper use of the device Proper use includes: · using the device for professional purposes, · having read this instruction manual, especially the "Safety instructions" section, · using the device within the operating conditions and limitations described in this instruction manual. "Improper use" means using the device other than as described in this instruction manual, or under operating conditions which differ from those described herein. 2 Safety instructions Safety instructions for the lithium polymer rechargeable battery The BA 300 battery is a lithium polymer rechargeable battery. Please understand that Sennheiser does not accept liability for damage arising from abuse or misuse. In extreme cases, the rechargeable battery may even present a · heat hazard · fire hazard · explosion hazard · smoke or gas hazard Charge rechargeable batteries only with the appropriate Sennheiser charger. When not using the rechargeable battery for extended periods of time, charge it regularly (every six months for about one hour). Charge rechargeable batteries only at ambient temperatures between 10°C/50°F and 40°C/104°F. Do not charge the rechargeable battery if the device is obviously defective. Return defective devices or devices with defective batteries to your specialist dealer. Do not heat above 70°C/158°F, e. g. Solution Remove obstacles in the light path between receiver and transmission system. Are transmission system Avoid exposure to direct sunlight. Is the rechargeable battery inserted properly into the receiver and fully charged?If this doesn't help: recharge the rechargeable battery (see page 7). Move the receiver closer to the transmission system. You can hear the sound only with one ear?Warning signal Meaning 6 short beeps The receiver is not receiving a signal from the transmission system: · The transmission system and receiver are too far apart from one another. Solution Turn the balance control 3 to the left or right (see page 6). If a problem occurs that is not listed in the above tables or if the problem cannot be solved with the proposed solutions, please contact your Sennheiser partner for assistance. 9 Accessories and spare parts Accessories and spare parts CAUTION!for power supply or rechargeable battery) may cause damage to the device and will invalidate the warranty. Use only original Sennheiser accessories and spare parts. The following HDI 1029-PLL16 accessories are available from your specialist dealer: Cat. 500898 502710 528123 528124 528125 531428 Accessory/spare part BA 300 spare rechargeable battery L 300 10-10 charger Earpads (silicone, black), 5 pairs Earpads (silicone, transparent), 5 pairs Earpads (foam, black), 5 pairs Swivel heads for earpads, 10 10 Specifications Specifications Modulation Receiving frequencies Frequency response Maximum SPL Signal-to-noise ratio (1 mV, peak deviation) THD Operating time Charging time for rechargeable battery Power supply FM, stereo 2. 3 MHz/2. 8 MHz 50 Hz­16, 000 Hz 125 dB (SPL) typ. 3 hours via BA 300 lithium polymer rechargeable battery (3. 7 V/150 mAh) approx. [. . . ] CE Declaration of Conformity This device is in compliance with the essential requirements and other relevant provisions of Directives 2004/108/EC and 2006/95/EC. Rechargeable and Non-Rechargeable Batteries Dispose of only discharged used rechargeable batteries and used batteries at a specialist dealer or in a battery collection container. Statements regarding FCC and Industry Canada This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]