User manual SENNHEISER TOURGUIDE SYSTEM 2020

[. . . ] System 2020 Tourguide Instruction manual Contents Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 System components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Overview of the system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 The operating controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To switch the radio microphone off: Press and hold the ON/OFF button ¸ until "OFF" appears on the display. The display ´ and the red LED µ go off. µ ¸ ² 29 Using the components Automatically switching the HDE 2020 D on/off The receiver automatically switches on when you pull the earbows ³ apart. When you release the earbows, the receiver switches to standby mode (audio deactivated) and then switches off after 2minutes. » Switching the EK 2020 D on/off ´ You can connect an induction loop or any pair of headphones with a 3. 5 mm mono or stereo jack plug to the headphone socket ² of the EK 2020 D. The headphone impedance must be 32 or higher. ² » Connect the 3. 5 mm jack plug of your headphones to the headphone socket of the EK 2020 D. To switch the receiver on: Briefly press the ON/OFF button ´ The display » switches on. To switch the receiver off: Press the ON/OFF button ´ . for 3 seconds. When you unplug the headphones from the receiver or switch off the transmitter, the receiver automatically switches off after 5 minutes. Switching the charging case on/off To switch the charging case on: Set the mains switch to the position "I". The LED POWER ² To switch the charging case off: Set the mains switch to the position "0". 30 Using the components Note: When not using the charging case for extended periods of time, switch it off and disconnect it from the mains by pulling out the mains connector from the wall socket. Adjusting the volume Adjusting the volume on the receiver CAUTION!Listening at high volume levels for long periods can lead to permanent hearing defects. Use · the volume control ¿ of the HDE 2020 D or · the volume control ³ of the EK 2020 D to adjust the volume so that you can hear the speaker's voice loud and clear. 6 ¿ ³ Note: The volume control ¿ or ³ has no end stop, i. you can turn it endlessly to the left or right. 31 Using the components Charging the rechargeable batteries CAUTION!· Only use the charging case for charging the SK 2020 D bodypack transmitter, the HDE 2020 D and EK 2020 D receivers and the BA 2015 accupack. · Never try to charge other rechargeable batteries or non-rechargeable batteries!Charging the accupack in the bodypack transmitter To charge the bodypack transmitter in the EZL 202020 L charging case: Place the transmitter with the accupack inserted into the charging compartment for accupack/bodypack transmitter ³ as shown in the diagram on the left. When placed into a charging compartment, the bodypack transmitter automatically switches off. The red LED CHARGE/ERROR · of the charging compartment lights up. · » After the accupack has been fully charged, the green LED READY » lights up. Notes: · Charging a completely discharged accupack takes approx. · Alternatively, you can remove the accupack from the bodypack transmitter and insert it into the charging compartment for accupack/bodypack transmitter ³ as described in the following section. · The charging case has no error indication like the one on the L 2015 charger ("red flashing LED"). 32 Using the components Charging the BA 2015 accupack ³ To charge the accupack of the radio microphone or bodypack transmitter: Remove the accupack as described on page 26 or page 27. Place the accupack into the charging compartment for accupack/bodypack transmitter ³ as shown in the diagram on the left. The red LED CHARGE/ERROR · of the charging compartment lights up. · » After the accupack has been fully charged, the green LED READY » lights up. [. . . ] 59 Manufacturer declarations Consumers may be entitled to statutory rights in their own countries which are not restricted by these warranty terms and conditions, as the warranty is governed by the laws of the country in which the Sennheiser product was purchased by the consumer. The provisions of the UN Convention on the International Sale of Goods do not apply to this service. If you wish to file a claim under the warranty, please send the product to your local service partner, together with accessories and proof of purchase. An up-to-date list of all service partners of Sennheiser electronic GmbH & Co. [. . . ]