User manual SAUNIER DUVAL EXACONTROL 1

[. . . ] Otherwise, water or refrigerant leakage could occur, as well as short-circuiting or even fire. It is convenient to regularly check the base of the outdoor unit to detect possible wear and tear. If a damaged base is not repaired, it could come away and cause an accident. Do not handle the unit with wet or damp hands as this would cause a risk of electrocution. [. . . ] This means that at the end of its useful life it should not be mixed with the rest of your unclassified domestic waste and its disposal should be undertaken in accordance with the local and national regulations applicable, in a correct and environmentally-friendly manner. This means that the user is obliged, at the end of the useful life of the unit, to submit it to an appropriate waste management company authorised by the local authorities, for transportation to a plant where it will receive proper treatment. In the event that the unit is being removed to be replaced with a new similar product, the old product can be submitted to the distributor of the new unit for waste management. This air conditioner has been designed for the following temperatures. Do not expose yourself to the direct airflow for prolonged periods of time. Season Summer Winter Indoor design conditions Operating temperature ºC Average air speed m/s 23 to 25 0, 18 to 0, 24 20 to 23 0, 15 to 0, 20 Relative humidity % 40 to 60 40 to 60 Set the airflow directed upwards in cooling mode and downwards in heating mode in order to obtain a regular room temperature. This product contains, amongst others, the following characteristics: Low noise emission from both the indoor and outdoor units. If it is locked, we cannot use any mode function or On/Off in the unit until it is unlocked. When batteries are removed from the remote control, they should be deposited in recycling bins. The clock is only displayed if timer AUTO-ON/OFF settings are selected. 3 5 2 Fan speed indicator Displays the selected fan speed in the AUTO mode and in the three fan speed levels "I" (LOW), "II" (MED), and "III" (HIGH). In order to activate: With the unit connected Press the SLEEP button to reduce the air flow sound from the indoor unit. If it is used uring the day, the cooling/heating capacity will be reduced since the room temperature is too high (COOL mode). In COOL mode The ambient temperature gradually increases 2ºC in relation to the configured one to ensure that the temperature does not drop excessively during sleeping hours. In HEAT mode The ambient temperature gradually decreases 5ºC in relation to the configured one to ensure that the temperature does not rise excessively during sleeping hours. - During the first operating hour of the SLEEP function, the ambient temperature will drop 2ºC below the configured temperature. - Once an hour has elapsed , the temperature will drop 2ºC more. - The unit will be operational for a further three hours before stopping. In order to set the unit to disconnect automatically: With the unit connected: Press the TIMER button. If you continue pressing it starts counting all over again The selected time will be shown on the remote controller display. During the countdown process the display will always show the remaining time In order to set the unit to connect automatically: Note!If you continue pressing it starts counting all over again The selected time will be shown on the remote controller display. [. . . ] after replacing the batteries , set the clock to the current time at the remote control. If batteries are removed from the remote control they must be segregated from the household waste and disposed according to the local requirements. Before proceeding to clean the unit, ensure that the entire unit and the magnetothermal switch are unplugged. 1- CLEANING THE AIR FILTERS The air filter eliminates the dust absorbed from the room into the indoor unit. [. . . ]