User manual SANGEAN RCR-5

[. . . ] The radio may fall, causing serious personal injury and damage to the radio. Ventilation: This radio should be situated so that its location or position does not interfere with its proper ventilation. For example, the radio should not be used on a bed, sofa, rug or other soft surfaces that may block the ventilation openings. It should not be placed in a built-in situation like a cabinet that may reduce air flow through the ventilation openings. [. . . ] While setting, the setting will be cancelled after 30 seconds without pressing any buttons. After the time is under setting, the setting won't be cancelled even you don't press any button for more than 30 seconds. You need to press the TIME SET button to complete the setting, and the second digit will be set to 0 at the moment when you press the TIME SET button. Press the TUNING up/down button, to tune into the frequency of your desired stations 2. scanning tuning- Press and hold the TUNING up/down button for more than 0. Select a STATION PRESET button (1-5) and press it for more than 2 seconds until a beep sounds and the station is now stored. Note: When you store a new station in a preset, the station previously stored will be automatically erased. Alarm setting can be done while the power is during ON or OFF position. The alarm clock is equipped with two alarm systems which can be operated independently of each other. Before the display goes back to the clock, press TIME SET button for 2 second until you hear the beep. Press the TIME SET button and then press the TUNING up/down button to select if the alarm should work on daily, weekday (Monday to Friday), weekend (Saturday and Sunday), or only once. If the RADIO ALARM is selected ­ press the TIME SET button and then select the radio band and the frequency to choose the alarm radio station. The setting will automatically complete the setting after 30 seconds without any button pressed. But when the ALARM RADIO is under setting, it will not complete automatically until the TIME SET of POWER button is pressed. After the alarm is set, the alarm status will be shown for 6 seconds then will go back to the clock. * HWS(Human Wake System): In buzzer alarm mode, the buzzer sound will increase in volume for 1 minute, then followed by 1 minute silence, then repeat the cycle for 1 hour. Deactivate alarm setting Press the ALARM 1 or ALARM 2 button for 2 seconds until you hear the beep. To reactivate the alarm, press the ALARM 1 or ALARM 2 button for 2 seconds until you hear the beep. With the NAP button, you can select the period for the short term alarm in 10 minutes steps from 10-120 minutes. If you wish to turn off the Nap timer before the time is up, simply adjust the number of minutes by pressing NAP button to OFF and release. [. . . ] If this radio was bought in Europe, the FM tuning step selections are 50KHz/step and 100KHz/step. : If you don't wish to make any change, don't press the TUNING up/down button. Plug in external audio devices such as CD player to the AUX IN socket (on the side of the radio), then play your device and press the BAND button repeatedly until you see "AU" on the display. Turn the Display Backlight Adjustment button to adjust the back light level. [. . . ]