User manual QUANTUM RACK MOUNT STUL816 CLL3200
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual QUANTUM RACK MOUNT STUL816 CLL3200. We hope that this QUANTUM RACK MOUNT STUL816 CLL3200 user guide will be useful to you.
Manual abstract: user guide QUANTUM RACK MOUNT STUL816 CLL3200
Detailed instructions for use are in the User's Guide.
[. . . ] LTO Autoloader Rackmount Kit
Installation Guide
Part Number 10010533-001 April 2003 Rev. All rights reserved.
LTO Autoloader Rackmount Kit
Rackmount Kit Installation
You can easily convert your LTO autoloader from a desktop to a rackmount configuration. [. . . ] This unit is intended to be connected to Earth ground.
Rackmount Kit Hardware
The tablebelow lists all items shipped with the rackmount kit. Description Rail assembly (right and left side) L-brackets (right and left side) Phillips screws Cage Nuts Washers Quantity 2 2 10 10 10
Tools Required · · Small flat-blade screwdriver # 2 Phillips screwdriver
Converting from Desktop to Rackmount
When converting a desktop autoloader to a rackmounted unit, you must install the rail assemblies onto the rack, attach the L-brackets to the autoloader, and then install the autoloader into the rack.
2
LTO Autoloader Rackmount Kit
Installing the Rail Assemblies to the Rack
The rackmount kit contains two rail assemblies that you mount to the rack. Open the shipping carton, remove the rail assemblies and associated hardware. Position two cage nuts on the front of the rack and two on the back of the rack. Position the left rail assembly on your rack, matching the holes on the front and rear of the rails with the holes on your rack, to which the cage nuts have been added. Using a # 2 Phillips screwdriver, attach the rail assemblies to your rack with four of the Phillips screws (two screws on the front and two on the back of the rack) and four washers. Note that the front of the rack is shown in the following illustration.
3
LTO Autoloader Rackmount Kit
Installing the L-Brackets on the Autoloader
The rackmount kit contains two front L-brackets. Power down the autoloader, then remove the SCSI cable(s) and power cord from the rear of the autoloader. Using a small flat-blade screwdriver, remove the front screws that secure the right and left side of the autoloader cover (two screws on each side). Match the holes on the L-brackets to the holes on the autoloader cover. [. . . ] Using a # 2 Phillips screwdriver, attach the L-brackets on each side of the autoloader to the rack with the two remaining Phillips screws and washers.
3. Reconnect the SCSI cable(s) and power cord to your autoloader (see the User's Guide). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE QUANTUM RACK MOUNT STUL816 CLL3200
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual QUANTUM RACK MOUNT STUL816 CLL3200 will begin.