User manual PRIMA PBL660R

[. . . ] Blender MODEL PBL660R USER GUIDE Visit our web site at: www. buyprima. com IMPORTANT SAFEGUARDS CAUTION: PLEASE TAKE CARE WHEN UNPACKING. Please read through the information and safety advice contained in these operating instructions carefully and thoroughly before you use the blender for the first time. Make sure that the voltage shown on the rating plate corresponds with that of the mains supply. [. . . ] Please note that this appliance is for domestic use only. Technical Information Voltage/frequency: 230V~50Hz (500W) Glass jug capacity: 1. 5 litres Parts and Assembly 1. Control switch IMPORTANT THE BLENDER IS EQUIPPED WITH A SAFETY INTERLOCK SWITCH. THIS IS FITTED TO PREVENT THE MOTOR FROM BEING ACTIVATED WHILE THE MACHINE IS DISASSEMBLED. THE MOTOR WILL NOT RUN UNLESS THE BLENDER JUG IS PROPERLY LOCKED INTO PLACE. ASSEMBLY Before first use it is a good idea to familiarise yourself with the assembly/disassembly of the unit. Note the position of the blender jug in relation to the base (as shown on the front cover of this book): 1. Line up the Glass Jug (3/9) with the handle to the right and turn slightly away from you. Place the Glass Jug (3/9) onto the Motor Block (7) and twist slightly until it falls into place. The motor will not run unless the blender Glass jug (3/9) is fitted properly. To remove the Glass Jug (3/9) assembly, turn it anti-clockwise and lift it away from the motor block (7) SETTINGS There are 3 settings 1, 2 and M (pulse). Setting 1 is low speed and is usually best for liquids or cooked vegetables. Setting 2 is faster and is usually best when you want to add some air to the mixture e. g. The (M) pulse setting allows for more control over the blending/chopping process. There may be occasions were you don't want the food pieces to be chopped too finely this setting can also be used for crushing ice. NOTE: In pulse mode if you release the switch it will automatically spring back to the 0 (off) position when released. It is only intended for short powerful bursts not continued use. Cleaning When cleaning this product please observe the following precautions: · · Always ensure the unit is switched off & unplugged from the mains Exercise extreme caution when handling the metal blades. These are very sharp. All parts except the Motor Block (7) can be washed with warm soapy water, rinsed and dried thoroughly. THE MOTOR BLOCK CONTAINS THE ELECTRICAL COMPONENTS. Useful Tips 1. [. . . ] IF YOU BOUGHT THIS PRODUCT VIA MAIL ORDER, PLEASE KEEP ALL THE DOCUMENTATION THAT CAME WHEN THE UNIT WAS DELIVERED. NAME___________________________________________________________________________________ ADDRESS________________________________________________________________________________ _________________________________________________________________________________________ PURCHASED FROM________________________________________________________________________ DATE OF PURCHASE ________________________________MODEL_______________________________ © Copyright 2006 Nu-World UK Ltd. All rights reserved. Nu-World UK Ltd, Prima House, 15 (2D) Springfield Commercial Centre, Bagley Lane, Leeds. [. . . ]