User manual PLEXTOR 8PL-1

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PLEXTOR 8PL-1. We hope that this PLEXTOR 8PL-1 user guide will be useful to you.


PLEXTOR 8PL-1 : Download the complete user guide (115 Ko)

Manual abstract: user guide PLEXTOR 8PL-1

Detailed instructions for use are in the User's Guide.

[. . . ] Model PX-83CS Internal and PX-85CS External FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee interference will not occur in a particular installation. [. . . ] If they were not provided by your soundboard manufacturer, you will need to purchase them from a local computer supply store. See the discussion about device drivers in Chapter 9 of this manual. Once you have assembled everything you need, you're ready to install your drive. But first, a few words of caution are in order. PX-83CS/PX-85CS OPERATION MANUAL 7 ---- CHAPTER 4 ---- Precautions YOUR TASK: YOUR OBJECTIVE: YOUR METHOD: Read the list of precautions below. Review the list and use common sense. Your new CD-ROM drive is a precision electromechanical device. Like the rest of your computer system, it requires reasonable care in its installation and use. Please read this manual carefully and keep it handy for easy reference. See your dealer, or call Plextor's Technical Support Department, should your drive require repair or service. # Do not put your computer monitor (or any other device weighing more than 30 lbs. ) on top of the 8PleX external drive. # Do not place your drive in direct sunlight, on heating units, or near electrical appliances that draw large amounts of current, such as a high-powered audio amplifier, microwave oven, toaster, hair dryer, etc. Keep the area around your drive clean from dust, smoke, and other contaminants. Do not allow moisture or liquids such as water, cleaning fluids, or solvents to touch the drive. Thinner, benzene, or alcohol-based solvents can mar your drive's surface. To help ensure that your CD-ROM discs remain free of dirt or other contaminants, your drive requires a disc caddy. Removing the cover may expose you to harmful electrical voltages or the laser beam. For your safety, entrust service to Plextor-authorized service personnel only. 8 PX-83CS/PX-85CS OPERATION MANUAL ---- CHAPTER 5 ---- Drive Features YOUR TASK: YOUR OBJECTIVE: Get to know your drive. Match the parts of your drive to the diagrams below. YOUR METHOD: PX-83CS Internal Drive----FRONT PANEL Door Closed Front Door Caddy Slot Audio CD Play Button Stop/Eject Button Volume 9 Headphone Jack Control Emergency Eject Hole ON/BUSY Indicator DISC Indicator Front Door: Open to insert caddy. During Audio CD play mode, however, push once to stop audio play and twice to eject caddy. if automatic eject button Emergency Eject Hole: Insert paper clip, or other thin, rigid object to eject caddy does not work. Turn off power before using this feature. PX-83CS/PX-85CS OPERATION MANUAL 9 CHAPTER 5 ---- Drive Features ON/BUSY Indicator: Yellow when power is on. Off if no disc is inserted. Volume Control: Controls volume of headphone jack. This control has no effect on the rear panel audio outputs. 9 Headphone Jack: Stereo mini-jack for headphones and powered speakers. PX-83CS Internal Drive----REAR PANEL Audio Output Connector SCSI Interface Connector Jumpers Power Connector Audio Output Connector: Outputs stereo analog signal. Use to connect to soundboard or audio amplifier. SCSI Interface Connector: Connects to SCSI interface board using 50-pin to 50-pin flat ribbon SCSI cable. Jumpers: Use to select SCSI ID number, parity, term, test, block size, and eject lock options. Leave these jumpers at their factory settings unless one or more of the following situations pertain to you: SCSI ID number: If you are using more than one SCSI peripheral, you may have to change your SCSI ID number, see page 15. Block size: If you are working in a UNIX environment and want to boot from your CD-ROM drive, see page 17. Eject lock: If you work in an environment where you need to prevent others from easily removing a CD-ROM disc from your drive, see page 17. Power Connector: Connects to your computer's power supply (DC +5V and +12V). 10 PX-83CS/PX-85CS OPERATION MANUAL CHAPTER 5 ---- Drive Features PX-85CS External Drive----FRONT PANEL Door Closed Front Door Caddy Slot Emergency Eject Hole Volume Control ON/BUSY Indicator 9 Headphone Jack DISC Indicator Stop/Eject Button Audio CD Play Button Front Door: Open to insert caddy. [. . . ] See page 18 for an explanation of SCSI termination and to determine if you need to change this setting. Leave this OFF, unless you are working in a UNIX environment and want to boot from your CD-ROM drive. However, if you are in an environment where you want to prevent others from borrowing or stealing the disc inserted in your drive (e. g. , the drive is located in a public place where multiple people have unlimited access), you can activate the Eject Lock feature. When this switch/jumper is ON, it is impossible to eject a disc inserted in the drive by pressing the Eject button. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PLEXTOR 8PL-1




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PLEXTOR 8PL-1 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.