User manual PHILIPS SQM4122

[. . . ] If you are unsure of any part of this installation, contact a professional installer for assistance or contact Customer Service at 1-919- 573-7854. â· This product has been designed for application on a vertical wall in commercial and residential buildings, constructed of wood wall studs or masonry (solid concrete, brick, and stone). If you are unsure of your wall composition or for assistance with other surfaces, contact a qualified installer. [. . . ] You can use your own stud finder or the one included in the hardware kit. With the help of another person, place the mount against the wall and level it using the bubble guide. While another person holds the mount in place, mark two locations (top and bottom) on the wall where the mount is to be installed. (these marks should line up with the ones made in step 3 above using the template). set the mount aside and drill a 1/8" (3 mm) pilot hole at each marked location. Place the mount back against the wall and secure it using the wood screws (A) provided. Do not over-tighten these screws and do not release the mount until all screws are in place. DNote Once stud has been located you will need to verify with a hammer and a nail A) Simply place the nail over your mark on the wall and tap in with hammer. If the nail encounters resistance and is secure in wall you have verified a stud location B) If it just pushes through with no resistance you will need to start over and locate the stud. 3 Using the enclosed mounting template, place the diagram against the wall and mark two locations (top and bottom) on the wall where the mount is to be Installed. 2 Mounting the wall plate (concrete/brick installation) BWarning For safety reasons, the concrete wall must be capable of supporting the combined weight of the mount and display. Using the enclosed mounting template, place the diagram against the wall and mark four locations on the wall where the mount Is to be Installed. With the help of another person, place the mount against the wall and level it using the bubble guide. While another person holds the mount in place, mark four locations on the wall where the mount is to be installed. [. . . ] For customer support or to obtain warranty service, please call 919-573-7854. Incidental, special and consequential damages are disclaimed where permitted by law. To complete the installation, simply slide the mount with your LCD attached into the wall piece. [. . . ]