User manual PHILIPS SENSEO HD7832

[. . . ] HD7832, HD7830 Coffee Machine 2 ENGlISh IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: Read all instructions before using the appliance. Care must be taken to prevent burns which can occur from touching hot parts or spilling hot liquids. To protect against fire, electrical shock and injury to persons, do not immerse cord, plug, or appliance in water or other liquid. Close supervision is necessary when any appliance is used by or near children. [. . . ] Note: Make sure the pod holder is clean and the sieve in the centre is not clogged, e. g. with loose coffee grounds. , If you want to make one cup of SENSEO\ coffee, use 1 coffee pod in combination with the 1-cup pod holder q and the 1-cup button q. , 11 , If you want to make two cups of SENSEO\ coffee, use 2 coffee pods in combination with the deeper 2-cup pod holder qq and the 2-cup button qq/w. 6 Place the SENSEO\ coffee pod(s) properly in the center of the pod holder, with the flat SENSEO\ side up and the rounded side facing down. Note: Use SENSEO\ coffee pods from Douwe Egberts specially designed for your SENSEO\ coffee machine for a full and round taste. Note:Make sure the coffee in the pod(s) is evenly distributed and press the pod(s) lightly into the pod holder. Note: Never put normal ground coffee or use torn pods in the SENSEO\ machine, as this will cause it to become blocked. , Place 1 SENSEO\ coffee pod in the 1-cup pod holder q or, , place 2 SENSEO\ coffee pods in the 2-cup pod holder qq. 7 Close the lid and lock the lever. The lid must be properly closed. 8 Place one cup or two cups under the spout openings. You can adjust the height of the coffee spout by sliding it upwards or downwards. Do not use cups that are too large, as they will cause the coffee to get cold more quickly. 9 Select the desired coffee volume by pressing the volume select button j. Cleaning Never immerse the SENSEO\ coffee machine in water or any other liquid. 3 Remove the coffee collector. Take the coffee spout out of the machine by sliding it upwards. The coffee spout can only be taken out after the coffee collector has been removed. , You can disassemble the coffee spout for more thorough cleaning! 1 5 Clean the coffee spout, the coffee collector and the drip tray in hot water, if necessary with some dish soap, or in the dishwasher. 6 Hold the cup tray in your hand while cleaning it with hot water, if necessary with some dish soap. To clean the cup tray, always remove it from the machine, as it might prove sharp when handled incorrectly. Always handle it carefully. 7 Clean the pod holders in hot water, if necessary with some dish soap, or in the dishwasher. If this is the case, unclog the sieve by rinsing the pod holder under a running tap. Use a soft dish brush to clean the sieve, if necessary. 8 Clean the water reservoir in hot water, if necessary with some dish soap. Note: If you are using a soft dish brush, be careful not to damage the valve in the bottom of the water reservoir. 9 Do not use an object with sharp edges to clean the water inlet on the machine. 10 Rinse the parts with fresh water after cleaning and put them back into the machine. 15 11 Clean the water distribution disc with a moist cloth. Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. If it does, the coffee machine will start leaking! Flushing If you have not used the coffee machine for three days, you have to flush it with fresh water before you use it again. Flush the machine in the following way: 1 Fill the water reservoir with cold water up to the MAX indication and put it back into the machine. 2 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine without pod(s). 3 Close the lid and lock the lever. Put a bowl (with a capacity of at least 1. 6 qt. /1. 5 litres) under the coffee spout to collect the water. 5 Press on/off button 3 (1) and subsequently press the 1-cup button q and the 2-cup button qq/w briefly at the same time (2). During the flushing cycle, the machine produces more noise than during a regular brewing cycle Never interrupt the flushing cycle halfway. [. . . ] If problems continue to occur, contact the Philips Norelco Service Location. The Senseo coffee machine brews only a small quantity of coffee or no coffee at all when it is used for the first time. If this is the case, unclog the sieve by rinsing the pod holder under a running tap. Flush the machine properly (see chapter `Preparing the machine for use') before you brew another cup of coffee. [. . . ]