User manual PHILIPS SBC RU880

[. . . ] INTRODUCTION You have made a great choice by buying this Philips universal remote control!It replaces up to eight separate remote controls and is pre-programmed to operate with almost any brand of TV, VCR, satellite tuner, cable decoder, CD-player, DVDplayer, tuner and amplifier. It can even learn the codes of other remote control units that are not pre-programmed. Best of all, the SBC RU880 is quick to set up and easy to use, and with the green back-lighting it can even be used in dimly lit rooms! [. . . ] 5 SETTING UP AN EXTRA DEVICE ON THE SBC RU880 The SBC RU880 has eight operating modes for operating eight different devices. It can also be programmed for any combination of devices contained in its library. the HOME mode on the SBC RU880 is factory pre-set to control the Philips Power Control System (see 5. `Setting up the SBC RU880 for your Philips Power Control System'), but you can change it to control, for example, a second TV. Also, make sure the equipment is switched on, and that you're sitting right in front of it. 1 If you know the brand name If you know the brand name of your second TV look at the code list at the back of this book to find the first 3-digit code for this TV. Then: 1 Press and hold the SMART key (for about three seconds) until the LCD displays TIMER. ­ If the code is correct, the display indicates OK for one second and returns to normal operation. Now press a few keys on the SBC RU880 to check that the equipment responds correctly. If it doesn't, try again from step 1 using the next code in the list. If none of the codes work properly, follow the instructions in the next section. Tip: Make a note of the code inside the battery case and in the back of this booklet in case you ever need to set up again. 2 If you don't know the brand name If you don't know the brand name of your equipment or if you cannot find it in the code list, set-up still won't take long. You will know the correct code has been found when the equipment switches off. Then: 1 Press the SMART key (for about three seconds) until the LCD displays TIMER. ­ The LCD displays OK for a second and then returns to normal operation. 1 COPYING THE FUNCTIONS OF KEYS 1 Press and hold the SMART key (for about three seconds) until the LCD displays TIMER. ­ The SBC RU880 is now ready to move keys and the LCD displays FROM. 6 Press the device key of the device you want to copy from, followed by the key you want to copy from. 7 Press the device key of the device you want to copy to, followed by the key you want to copy to. ­ After you've pressed this key, the LCD displays OK for a second and the SBC RU880 goes back to normal operation. To programme a macro: 1 Press the SMART key (for about three seconds) until the LCD displays TIMER. [. . . ] ­ The SBC RU880 displays ALL OFF during key-press and then displays the last selected appliance. The Power Control system's house code prevents interference with a similar system in your neighbour's house. Power Control Systems only respond to signals with the correct house code. To change the house code: Verify that the house code already is installed. [. . . ]